Loading ...
Loading ...
Loading ...
Driving
Disconnecting and deactivating the ACC
●
To disconnect the ACC move the lever to
position (fix
ed)
›
›
›
Fig. 276
0
. An ACC de-
activated message appears and the func-
tion is t
ot
ally deactiv
at
ed.
If you do not wish t
o disconnect the ACC, just
to switch it temporarily to inactive mode
(Standby), move the third lever to position
3
or press the brake pedal.
It will al
so s
wit
ch t
o inactiv
e mode (Standby)
if the vehicle is stopped and the driver door is
opened.
Adjusting the default distance level at the
start of your journey
In wet road conditions, you should always set
a larger distance with regard to the vehicle in
front than when driving in dry conditions
›››
.
In the Easy Connect syst
em, you can pr
e-se-
l
ect the dist
ance l
evel when connecting the
ACC to: Very short, Short, Medium, Long and
Very long using button > Vehicle >
SETTINGS > Driver assistance
›››
page 92.
Changing the driving profile
In vehicles with SEAT Drive Profile, the driving
profile selected can have an influence on the
ACC’s acceleration and braking behaviour
›››
page 264.
In vehicles without SEAT Drive Profile, the be-
haviour of the ACC can also be affected if
any of the following drive profiles are selec-
ted in the Easy Connect system:
●
Normal
●
Sport
●
Eco
●
Convenience
In this case you must access the ACC set-
tings using button > Vehicle >
SETTINGS > Driver assistance > ACC
›››
page 92.
The following conditions may lead the
ACC not to react:
●
If the accelerator is pressed.
●
If there is no gear engaged.
●
If the ESC is controlling.
●
If the driver is not wearing his/her seat belt.
●
If several brake lights of the vehicle or elec-
trically connected trailer are damaged.
●
If the vehicle is reversing.
●
Driving faster than 210 km/h (130 mph).
Driver messages
ACC not available
●
The system cannot continue to guarantee
safe vehicle detection and is deactivated.
The sensor has lost its setting or is damaged.
Take the vehicle to a specialised workshop
and have the fault repaired.
ACC and Front Assist: currently
not available. No sensor vision
●
This message is displayed if the radar sen-
sor's visibility is impaired by leaves, snow,
dense fog or dirt. Clean the sensor
›››
Fig. 275.
ACC: currently not available.
Gradient too steep
●
The maximum road slope has been excee-
ded, hence safe ACC operation cannot be
guaranteed. The ACC cannot be switched
on.
ACC: only available in D, S or M
●
Select the D/S or M position on the selector
lever.
ACC: parking brake applied
●
The ACC is deactivated if the parking brake
is applied. The ACC is available once again
after the parking brake is released.
ACC: currently not available. In-
tervention of stability control
●
The indication is displayed when the elec-
tronic stability control (ESC) intervenes. In this
case, the ACC is automatically switched off.
280
Loading ...
Loading ...
Loading ...