Loading ...
Loading ...
3
INSTALLATION REQUIREMENTS
Electrical Requirements
■ 115-volt (103.5 min. - 126.5 max.)
■ 0-12 amps
■ 15-amp time-delay fuse or circuit-breaker
■ If there is a “Single Circuit Only” label on the unit, use on
a dedicated single-outlet circuit only. If a dedicated single-
outlet circuit is not available, then it is the customer’s
responsibility to have a single-outlet circuit installed by
a qualied electrician.
■ If there is no “Single Circuit Only” label on the unit, the unit
may be used on any branch circuit of correct voltage and
adequate current protection rating.
Recommended Grounding Method
This dehumidier must be grounded. This dehumidier is
equipped with a power supply cord having a grounded 3 prong
plug. To minimize possible shock hazard, the cord must be
plugged into a mating, grounded 3 prong outlet, grounded in
accordance with all local codes and ordinances. If a mating outlet
is not available, it is the customer’s responsibility to have
a properly grounded 3 prong outlet installed by a qualied
electrical installer. It is the customer’s responsibility:
■ To contact a qualied electrical installer.
■ To assure that the electrical installation is adequate and
in conformance with National Electrical Code, ANSI/NFPA
70 - latest edition, and all local codes and ordinances.
Copies of the standards listed may be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02269
Electrical Requirements—All Models
The electrical ratings for your dehumidier are listed on the model
and serial number label. The model and serial number label is
located on the right-hand side of the dehumidier cabinet.
Specic electrical requirements are listed in the “Power Supply
Cord Electrical Requirements” chart. Follow the requirements for
the type of plug shown in the chart.
Installation Instructions
WARNING
Excessive Weight Hazard
Use two or more people to move and install
dehumidifier.
Failure to do so can result in back or other injury.
Remove Packaging Materials:
■ Handle the dehumidier gently while unpacking the unit.
■ Remove the carton top and lift the dehumidier from the
base pad.
■ Remove tape and glue residue from surfaces before turning
on the dehumidier. Rub a small amount of liquid dish soap
over the adhesive with your ngers. Wipe with a damp cloth
and dry.
■ Do not use sharp instruments, rubbing alcohol, ammable
uids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your dehumidier.
■ Dispose of/recycle packaging materials in an appropriate way.
Placement
This dehumidier may be placed on a stable, level, and solid
oor that will support its weight. Allow at least 2
1
⁄2" (6.35 cm)
of clearance from walls and furniture. Do not allow the air inlet
or outlet to be covered by drapes or curtains, as it will reduce
performance.
2.5"
(6.35 cm)
2.5"
(6.35 cm)
Loading ...
Loading ...
Loading ...