Loading ...
Loading ...
Loading ...
13
Figure 11
Figure 12
Trap
Filter
Cylinder
Fine Filter
Figure 13
Large Object
Care and Maintenance
Maintenance Tasks
Certain areas of the dishwasher require occasional maintenance. The maintenance tasks are easy to do and will
ensure continued superior performance from your dishwasher.
Wiping up spills and splash-outs
Water may occasionally splash out of your dishwasher, particularly if you interrupt a cycle or open the dishwasher
door during a cycle. To avoid floor damage and possibly mold growth, do not allow wet areas to remain around or
under the dishwasher.
Clean the stainless steel inner door and tub
Clean the outer edges of the inside door panel regularly to remove debris that may col-
lect from normal loading. If spots begin to appear on the stainless steel, make sure the
rinse agent is full and functioning properly.
Check and clean spray arm nozzles
Remove the top spray arm by first removing the empty top rack from the dishwasher.
Turn the rack upside down. The top spray arm is held in position by a locking nut as
shown in Figure 11. Turn the locking nut counterclockwise and remove it to release the
spray arm. Look for obstruction in the spray nozzles. If the spray nozzles need clean-
ing, flush them under running water.
To reinstall the top spray arm, place it back in position and return the locking nut to its
install position. Turn the locking nut clockwise to secure. Return the top rack to the
top rack roller guides.
Remove the bottom spray arm by first removing the empty bottom rack from the dish-
washer. Grasp and lift the spray arm as shown in Figure 12. Look for obstruction in the
spray nozzles. If the spray nozzles need cleaning, flush them under running water.
To reinstall the bottom spray arm, return the bottom spray arm to the installed posi-
tion and press it until it snaps into place. Return the bottom rack to the installed posi-
tion.
Check and clean the filter system
The filter system consists of a Large Object Trap/Cylinder Filter assembly, a
Fine Filter and a Micro Filter. The filter system is located on the inside of
your dishwasher under the lower rack and is easily accessible. During nor-
mal use, the filter system is self-cleaning. You should occasionally inspect it
for foreign objects and clean it when necessary.
CAUTION
To avoid injury, do not reach into the large object trap with your fingers.
The large object trap could contain sharp objects.
To remove the Large Object Trap, remove the bottom rack. Grasp the assembly and turn
it counterclockwise. Lift the assembly out.
Carefully examine the assembly. If you find debris in the Large Object Trap, turn it
upside-down and gently tap it on a flat surface to dislodge and remove debris.
Remove the Micro Filter as shown in Figure 14 on page 14.
Flush the Micro Filter and Fine Filter clean by holding them under running water.
To reinstall the filter system, return the Micro Filter to the installed position. Place the
Large Object Trap/Cylinder Filter Assembly and Fine Filter into the installed position.
Turn the locking nut clockwise until it is locked. The arrow on the ring handle and the arrow on the Fine Filter
should point at each other.
Loading ...
Loading ...
Loading ...