Loading ...
Loading ...
Loading ...
8. Bluetooth playback
Before transmission between your Bluetooth device and the radio is possible, both devices
must be coupled. This process is called "pairing". The Tuner is served as a receiver, to receive
music stream to play on the Tuner.
If you have already coupled to a Bluetooth device before, this connection will be restored
automatically when both devices are in range and Bluetooth operation has been selected on
the radio. "Pairing" does not have to be repeated. This function may need to be activated in
your Bluetooth device, however.
•Push the Menu button to display the selection menu for the different operating modes.
• Use the up / down button to select the operating mode Bluetooth and push the dial switch.
• Switch your Bluetooth device to which you want to connect the radio on and activate the
pairing mode here. The device scans for Bluetooth devices in the reception range.
• When the radio is found, your bluetooth device shows its name WR-230S-XXXX (the XXXX is
an identification code for your radio unit).
• Select the radio at your bluetooth device.
• Start playback on your bluetooth device.
• Playback now takes place using the radio.
- 11 -
Manual Tune
To manual tune to the frequency, long press the [OK]on remote or long press [Tune/Select]
on the unit, until you see the "Tuning"appeared on the display, at the bottom right corner.
Use the <◄ / ►> button on remote to tune the frequency. When done, long press the [OK]
button to exit manual tune.
9. Aux-In
You can listen to the music stored in other audio device or smart phone on the radio, through
the connection to the 3.5 mm aux-in jack on the rear side. Use the cable with both ends in 3.5
mm pin, one end to the aux-in jack on the radio, the other end to the earphone jack on the
audio device or if it has line out socket.
Loading ...
Loading ...
Loading ...