Loading ...
Loading ...
Loading ...
49-7769
FEATURES OF THE ZONELINE
Features
About Your Heat Pump (on some models)
+HDWSXPSVFDQUHGXFHRSHUDWLQJFRVWVE\H[FKDQJLQJ
heat from the outside air—even when the outside
temperature is below freezing— and releasing that heat
indoors.
7RJHWWKHEHVWHFRQRPLFEHQHILWIURP\RXUKHDWSXPS
don’t change the room thermostat setting very often.
Raising the heat setting 2–3 degrees will cause the
=RQHOLQHWRXVHLWVHOHFWULFKHDWLQJHOHPHQWVLQRUGHUWR
reach the new temperature setting quickly.
7KHUHLVDWKUHHPLQXWHPLQLPXPFRPSUHVVRUUXQWLPHDW
any setting to prevent short cycling.
7KHLQGRRUIDQPRWRUVWDUWVEHIRUHWKHFRPSUHVVRUDQG
stops after the compressor cycles off.
7KHHOHFWULFKHDWLQJHOHPHQWVXVHPXFKPRUHHOHFWULFLW\
than heat pumps and cost more to operate.
Power Disconnect
7KHSRZHUGLVFRQQHFWLVORFDWHGRQWKHIURQWRIWKH
=RQHOLQH
NOTE:7KHSRZHUGLVFRQQHFWGRHVQRWUHPRYHSRZHUIURP
WKHWHUPLQDOEORFNORFDWHGXQGHUWKHFRQWUROER[SDQHO
Ventilation Control
7KHYHQWLODWLRQFRQWUROOHYHULVORFDWHGRQWKHIURQWRIWKH
=RQHOLQHXQLW
When the lever is in the CLOSE position, only the air inside
the room is circulated and filtered.
When the lever is in the OPEN position, some outdoor air
ZLOOEHGUDZQLQWRWKHURRP7KLVZLOOUHGXFHWKHKHDWLQJRU
cooling efficiency.
To close the vent, move the slide lever to the right.
To open the vent, move the slide lever to the left.
Energy Tip: Keep the vent control in the CLOSE position.
7KHURRPDLUZLOOEHILOWHUHGDQGFLUFXODWHG
NOTE: Ventilation openings are not intended to be the
source of make-up air for building ventilation systems due to
the additional heating and cooling loads generated.
Power
'LVFRQQHFW
Close
Room Freeze Protection
7KLVIHDWXUHZLOOPRQLWRUWKHLQGRRUURRPFRQGLWLRQVDQGLQ
WKHHYHQWWKDWWKHURRPIDOOVEHORZ° the unit will cycle on
KLJKIDQZLWKWKHHOHFWULFKHDWHU7KLVRFFXUVUHJDUGOHVVRI
mode as long as power is applied to the unit.
Ventilation
Control Slide
Lever
&RQWURO%R[
Panel
WARNING
Electric Shock Hazard
%HIRUHVHUYLFLQJGLVFRQQHFWSRZHUWRWKH=RQHOLQHDW
WKHIXVHER[RUFLUFXLWEUHDNHUDQGSXOORXWHOHFWULFDO
disconnect on front of the chassis.
Failure to do so can result in personal injury and/or
death.
Loading ...
Loading ...
Loading ...