Loading ...
Loading ...
Loading ...
35
IF YOU EXPERIENCE POSSIBLE CAUSES SOLUTION
Nothing will operate. A household fuse has blown
or a circuit breaker has tripped.
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
Surface burners will not
operate.
This is the rst time the surface
burners have been used.
Turn on any one of the surface burner knobs to release air from
the gas lines.
The control knob is not set
correctly.
Push in knob before turning to a setting.
The burner ports are clogged. Clean clogged burner ports with a straight pin.
Surface burner ames
are uneven, yellow, and/
or noisy.
The burner ports are clogged. Clean clogged burner ports with a straight pin.
The burner caps are not
positioned properly.
Make sure cap is properly aligned with the burner.
Propane gas is being used. The range may have been converted improperly. Contact
a trained repair specialist.
A tone sounds or indicator
light ashes from the unit.
An invalid mode and temperature
selection has been made.
Make sure that a valid mode and temperature selection has
been made according to the "Knob Combinations" chart.
An invalid Start button selection
is made.
If an invalid knob combination has been chosen and the
Start button is pressed, the indicator light will quickly blink
and a tone will sound to indicate that the chosen selection
is invalid. See the "Knob Combinations" chart for valid knob
combinations.
The timer from the application
has ended.
The tone will sound every ve minutes until the timer is stopped
on the application.
The Meat probe has been
disconnected.
Reconnect the meat probe.
Surface burner makes
popping noises.
The burner is wet. Let it dry.
Burner sparks but does
not light.
There is continuous sparking, but
the burner does not light.
Make sure cap is properly aligned with burner.
If sparking continues, discontinue use of the surface burner and
contact a service technician.
Excessive heat around
cookware on cooktop.
The cookware is not the proper
size.
Use cookware about the same size as the surface cooking
area or surface burner. Cookware should not extend more
than 1/2" (1.3 cm) outside the cooking area.
Cooktop cooking results
not what expected.
The proper cookware is not being
used.
Use medium-to-heavy cookware made of the material that
cooks food the way you want. The best cookware should have
a at bottom, straight sides, and a well-tting lid.
The control knob is not set to the
proper heat level.
Set the Cooktop Control to HI, MED, or LO, depending upon
the type of cooking you want to do.
The range is not level. The range must be level for the griddle to operate properly.
See the Installation Instructions for leveling instructions.
Oven will not operate. The electronic oven control is not
set correctly.
Make sure you have followed the instructions for the function
you want to perform.
A Delay Start has been set via the
App.
This will cause the oven to start at a later time.
On some models, the Sabbath
Mode is set.
This mode allows oven operation in keeping with the Jewish
Sabbath. See Sabbath Mode section for disabling.
The temperature knob is not set
to a proper temperature setting.
Push in knob before turning to a setting and verify that the knob
is located on a setting.
The start button is not properly
operating.
Allow the start button to blink before pressing start.
The updated cooking mode
selected is not working properly.
Moving too quickly between cooking modes can cause issues
with getting the desired mode started.
First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a
service call, refer to the “Warranty,” or visit https://jennair.custhelp.com. In Canada, visit http://www.jennair.ca.
TROUBLESHOOTING
Loading ...
Loading ...
Loading ...