Loading ...
Loading ...
Loading ...
Operating the appliance en
15
Calibrating the appliance and cleaning the cooking
compartment
Notes
■ Calibration cannot be started until the cooking
compartment is cold (room temperature).
■ Do not open the appliance door while calibration is
in progress, as this will abort the calibration process.
1. Use the # touch button to switch on the appliance.
2. Fill the water tank. ~ "Filling the water tank"
on page 19
3. Set the specified type of heating, temperature and
duration for the calibration, then start the appliance.
~ "FullSteam – Steam cooking" on page 17
4. Heat up the appliance following calibration.
Caution!
Enamel damage
Do not use the appliance if there is water on the
cooking compartment floor. Before using the
appliance, wipe away the water from the cooking
compartment floor.
5. Dry the cooking compartment floor.
6. Set the specified type of heating and temperature for
heating, then start the appliance. ~ "Setting and
starting the appliance operation" on page 15
7. Keep the kitchen ventilated while the appliance is
heating.
8. Stop the appliance once the specified time has
elapsed. Use the # touch button to switch off the
appliance.
9. Wait for the cooking compartment to cool down.
10. Clean the smooth surfaces with soapy water and a
dish cloth.
11. Empty the water tank and dry the cooking
compartment. ~ "After every steam operation"
on page 20
Notes
■ When relocating the appliance, restore its factory
settings once it is installed so that it can adapt to its
new location. Repeat the procedures for initial start-
up and calibration.
■ The appliance retains the calibration settings, even
in the event of a power cut or disconnection from the
mains. Calibration does not need to be repeated.
Cleaning the accessories
Clean the accessories thoroughly using soapy water
and a dish cloth or soft brush.
1Operating the appliance
Oper at i ng the appl i ance
You have already learnt about the controls and how
they work. Now we will explain how to set your
appliance. You will learn about what happens when you
switch the appliance on and off, and how to select the
operating mode.
Switching the appliance on and off
To switch the appliance on or off, touch the # touch
button.
After the appliance has switched off, the display shows
whether the residual heat in the cooking compartment
is high or low.
Notes
■ Certain indicators and instructions (e.g. about
residual heat in the cooking compartment) remain
visible on the display even when the appliance is
switched off.
■ After the appliance has completed an operation, you
will hear the cooling fan continuing to run until the
cooking compartment is cooled as much as
possible.
■ Switch off your appliance when you do not need to
use it. If no settings are made for a long time, the
appliance switches off automatically.
Setting and starting the appliance operation
Example: ‚ CircoTherm hot air at 170 °C
1. Touch the # touch button to switch on the
appliance.
You go directly to the ¢ Types of heating menu.
2. Swipe to the left or right to select the type of heating.
3. Touch the bottom line.
4. Swipe to the left or right to select the temperature.
Calibration
Type of heating Steam ‹
Temperature 100 °C
Cooking time 30 minutes
Heating up
Type of heating CircoTherm ‚
Temperature Maximum
Cooking time 30 minutes
Display Temperature
Residual heat high above 120 °C
Residual heat low between 60 °C und 120 °C
&
&LUFR7KHUP
&
&
&
&
&
&LUFR7KHUP
Loading ...
Loading ...
Loading ...