Loading ...
Loading ...
Loading ...
Packing Instructions
Washing
Machine
(1)
Manual
(1)
Drain Hose
Assembly
(1)
Water Inlet
Hose Assembly
(1)
Down
Pressing Plate
(1)
Warranty
Card
(1)
Parts Names
Outer
Drum Rim
Circulation
Water Channel
Adjustable
Foot (1)
Drain Hose Assembly
Pulsator
Washing/Spin-
drying Drum
Panel
Frame
Detergent Mouth
Cap
Power Cord
Power Cord Plug
Water Inlet Hose
Assembly
Faucet
(This diagram is for reference
only. The actual product shall prevail.)
Operation
Panel
Drum Cover
Lint Filter
Housing
Installation Instructions
Solid and
Steady Ground
Tilted Ground
Unsteady Ground
Support Stand
and Platform
Loosen
Lower
Raise
Bottom Bracket
Tighten
Adjustable Foot
Adjustable Foot
Bottom Bracket
Placement of the Washing Machine
1. Choose a dry place without direct sunlight to the Washing Machine.
2. Place the Washing Machine on steady solid ground.
3. The washing machine should be placed where there
is a suitable drainage and can drain water smoothly.
The drainage shall be on the same plane that the
machine is placed on or slightly lower than the plane,
to avoid Washing Machine leakage causing any
damage.
4. Place the Washing Machine as firmly as possible.
If necessary, level the Washing Machine by
adjusting the Adjustable Feet of the Washing
Machine according to the order shown in the figures.
The maximum allowable inclination of the plane on
which the Washing Machine is placed is 2°.
Notes:
• When the Washing Machine is placed on the floor
or a flexible support stand, the Washing Machine
may vibrate.
• Do not place any object such as a carpet below the
Washing Machine to prevent the bottom opening
from being blocked.
Faucet Selection
Faucet Type: (the faucet mouth shall be
smooth)
Type A: The most appropriate
Type B: Faucet length must be greater
than 16mm. Otherwise the universal joint
cannot be installed.
Type C: Water leakage may occur with
the part shown in the figure.
Type A
Type B Type C
• If you do not use the appropriate faucet,
please replace it.
16mm above
Water leakage may occur
with this part.
Notes:
1. When installing the Washing Machine, please be sure to remove the Pedestal and Bracket
for transportation at the bottom of the Washing Machine. Otherwise it cannot be used.
2. During installation or initial use, a small amount of water will flow out of the Drain Hose,
which is residual water left over from the factory during routine inspection.
3. Unplug the Power Cord when Washing Machine is not in use and turn off the faucet to
avoid accidental fires and water leakage accidents.
Rat Guard
(1)
War ranty C ard
Tempered Glass
Loading ...
Loading ...
Loading ...