Loading ...
Loading ...
Loading ...
8
Lowes.com/harborbreeze
CAUTION: Ensure all screws are tight before moving
onto the next step.
STANDARD/ANGLE-MOUNTING INSTRUCTIONS
3. Cut off excess fixture wires, leaving approximately 6 to
9 inches above the top of the downrod assembly (B).
Strip 1/2 inch of insulation from the end of each fixture
wire.
4. Carefully lift the assembly and rest the hanger ball of
downrod assembly (B) on the mounting bracket (A)
attached to the outlet box. Be sure the groove in the
hanger ball is lined up with the tab on the mounting
bracket (A). This will allow for hands-free wiring.
Proceed to WIRING on page 10.
DANGER: Be careful when aligning the tab to the slot !
If not fully engaged, there is a possibility of the fan
falling, which may result in serious injury or death.
2. Feed power wires from motor housing (F) through
downrod assembly (B), then insert downrod assembly
(B) into the coupling (P) on motor housing (F).
Align the hole on downrod assembly (B) to hole on
coupling (P), then re-install clevis pin (R). Re-attach
hairpin clip (S) into clevis pin (R) until it snaps into
place, then tighten the two previously loosened
coupling screws (T).
3
6 to 9 in.
D
E
C
S
R
P
T
B
2
F
4
Hanger Ball
Tab
Slot
A
B
Loading ...
Loading ...
Loading ...