Loading ...
Loading ...
Loading ...
9
Using Your Dryer
WARNING: To reduce the risk of re, electric shock, or injury to
persons, read the IMPORTANT SAFETY INSTRUCTIONS before
operating this appliance.
1. Empty water tank
Hold the handle and carefully pull out the water tank.
Holding the full water tank with both hands, empty out the
water. Then push the container back into place. Make sure
that it is properly inserted.
2. Clean door lint screen
Clean the lint screen before or after each load. Pull the lint
screen straight up and out. Press tab down and open lint
screen. Roll lint off the screen with your fingers. Push the lint
screen firmly back into place.
IMPORTANT: Clean lint screen before each dryer use
as a screen blocked with lint will increase drying time.
3. Clean bottom lter
Clean the bottom filter after every 3 cycles. Open the filter
door on the bottom of the dryer and grab the handle to pull
out filter. A small amount of water may escape from the area.
Placing a absorbent towel under the flap will capture the
water. Clean the filter by hand or rinse with water – do not
wash the filter foam in a washer. Wring out the filter foam – do
not insert it in the bottom filter dripping wet. For additional
cleaning information, see “Dryer Care.”
Replace the bottom filter in the filter chamber. Fold the filter
handle down and close the bottom door.
NOTE: To turn off the “Clean bottom filter” status indicator,
the filter must be removed and replaced with the Power
button touched ON and no cycle running.
4. Rinse the Heat Exchanger
Approximately every 3 months the heat exchanger will need
to be cleaned. Cool the machine down completely. A small
amount of water may escape, therefore place an absorbent
cloth under the maintenance flap. Remove the bottom filter,
shown in step 3. Turn down both locking levers, and remove
the heat exchanger. Rinse the heat exchanger thoroughly,
removing all of the lint.
Loading ...
Loading ...
Loading ...