Loading ...
Loading ...
Loading ...
14
INSTALLATION INSTRUCTIONS
Installation Requirements
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Tools needed:
Flat-blade screwdriver #2 Phillips screwdriver
Min. 8" long TORX
®
T20
®†
screwdriver
Wire stripper (direct wire
installations)
Channel locks
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
1/4" and 5/16" nut driver
(recommended)
Utility knife
Tape measure
Level
Pliers
If using a power supply cord:
Use a UL-listed power supply cord kit marked for use with
clothes dryers. The kit should contain:
Ƀ A UL-listed 30 A power supply cord, rated 120 V/240 V
minimum. The cord should be type SRD or SRDT and
be at least 4 ft. (1.22 m) long. The wires that connect to
the dryer must end in ring terminals or spade terminals
with upturned ends.
Additional Accessories: (Not supplied with dryer)
Refer to “Operating Instructions” for information about
accessories available for your dryer.
†
®
TORX and T20 are registered trademarks of Acument Intellectual Properties, LLC.
Loading ...
Loading ...
Loading ...