Select a place with strong, level floor. If the floor is not quite level, adjust the height of
the feet accordingly.
Allow sufficient clearance between the refrigerator s’ back, also the side wall, so the door
can open fully and to minimize noise.
Avoid direct sunlight and heat. Direct sunlight may affect the enamel coating.
Heat sources nearby will cause higher electricity consumption.
Avoid very moist place. Too much moisture in the air will cause frost to from very quickly
on the evaporator, and the refrigerator will have to be defrost very frequently.
After re-located, leave the fridge s 3-6 hours before switching it on. This intendtanding
to ensure a proper cooling system operation.
Make a test run
Your refrigerator is usually cleaned by manufacture, however you may want to
clean it before using with a soft towel cloth.
After cleaned, replace all parts in proper.
Keep the door open and plug the power cord into its own electrical outlet.
The interior lamp should lit.
4. Properly close the door.