Loading ...
Loading ...
Loading ...
Mesh filters installation (for models: 54800 and 54810).
It is recommended to install side filters first and finish with center one(s).
Install as follows:
1) Insert upper end of filter into the hood (filter tab side).
2) Raise lower end toward the inside of hood.
3) Position rear part of filter into channel and pull.
4) Using filter tabs, puii on the upper end of filter and slide it under the front inner retaining piece.
i
HDOOOg
Replacement filters are available. |
Refer to page 12 for ordering information.
1
Baffle filters installation (for models: 54820, 54830 and 54840 only).
_hb CAUTION: Remove protective plastic film covering filters before installlng them.
It is recommended to install side filters first and finish with center one(s).
Install as follows:
Make sure the filters are positioned as shown thus allowing the grease to reach the channel easily.
A verical arrow with the word AIR can be found on filter border; make sure to install the filter with the arrow aiming
toward the inside of the hood. See illustrations below.
H
i
i
i
io
Loading ...
Loading ...
Loading ...