Loading ...
Loading ...
Loading ...
SEIROSSECCA DNA NEVO
1. Remove all packing materials from the oven cavity, (do not remove the waveguide cover), and the feature
sticker from the outside of the door, if there is one. Check the unit for any damage, such as a misaligned
door, damaged door seals around the door or dents inside the oven cavity or on the door. If there is any
damage, please do not operate the oven until it has been checked by a SERVICE CENTRE APPROVED BY
SHARP and repaired, if necessary.
2. Accessories provided
1) Turntable 2) C oupling-Already fitted to motor shaft
4) Operation manual and Grill Rack
3. Ensure the coupling has been fitted to the motor shaft, then place the turntable onto the coupling,
ensuring it is located fi rmly. NEVER operate the oven without the coupling
and turntable.
4. This oven is designed for countertop or open cavity use. It should not be installed in any area where
excessive heat and steam are generated, for example, next to a conventional oven unit. The oven
should be installed so as not to block ventilation openings. Allow a space of at least 30 cm on the top,
5 cm on both sides and at the rear of the oven for adequate air circulation. When installing in a cabinet,
the minimum inside dimension of the cabinet should be 620 mm (W) x 636 mm (H) x 560 mm (D). This
oven is not designed for built-in installation.
WARNING: The electrical outlet must be readily accessible so that the unit can be unplugged easily in an
emergency.
5. Neither the manufacturer nor the distributor can accept any liability for damage to the machine or personal
injury for failure to observe the correct electrical connecting procedure.
The A.C. voltage must be single phase 230V-240V, 50Hz.
6. This appliance must be earthed.
7. Operate the oven from a general purpose domestic outlet.
If a generator is used, do not operate the oven with non-sinusoidal outputs.
INSTALLATION INSTRUCTIONS
OVEN
ACCESSORIES:
Check to make sure the following accessories are
provided:
(17) Turntable (19) Coupling-Already fitted to motor shaft ( ) Rack
• Ensure the coupling has been fitted to the motor shaft,
Then place the turntable onto the coupling,
ensuring it is located rmly.
• To avoid turntable damage, ensure dishes and
containers are lifted clear of the turntable rim when
removing them from the oven.
• For use of the rack, refer to the grilling sections on page A-4
and pages 11-13.
Never touch the grill when it is hot.
NOTE: When you order accessories, please mention
the following: Part name and model name to your
dealer or SHARP authorised service agent.
19. Coupling
- The waveguide cover is fragile, care should be taken.
- Always clean the cavity, especially the grill element.
- Always operate the oven with the turntable and
turntable support tted correctly.
2
7
8
3
9
12
456
11
10
1
13
14
15
1. Door
2. Door hinges
3. Oven lamp
4. Waveguide cover (DO NOT REMOVE)
5. Coupling
6. Oven cavity
7. Convection fan (covered)
8. Grill heating element (under the ceiling)
9. Control panel
10. Door latches
11. Door seals and sealing surfaces
12. Door safety latches
13. Ventilation openings
14. Outer cabinet
15. Power supply cord
20
20. Rack
Hub (inside)
17. Turntable
(glass)
18. Turntable
support
Turntable support3)
4
Loading ...
Loading ...
Loading ...