Loading ...
Loading ...
Loading ...
Probe (lower oven)
The temperature probe may be cleaned with soap
and water or a soap-filled scouring pad. Cool the
temperature probe before cleaning. Scour stubborn
spots with a soap-filled scouring pad, rinse and dry.
Do not immerse the temperature probe in water.
Do not store the temperature probe in the cooking
center.
Control Panel
It’s a good idea to wipe the control panel after each
use. Clean with mild soap and water or vinegar and
water, rinse with clean water and polish dry with a
soft cloth. When cleaning, the control panel should
be at room temperature and not in direct sunlight.
Do not use abrasive cleansers, strong liquid cleaners,
plastic scouring pads or oven cleaners on the control
SDQHO³WKH\ZLOOGDPDJHWKHILQLVK$VROXWLRQ
of vinegar and hot water works well.
'RQRWUXERUFOHDQWKHGRRUJDVNHW³
it has an extremely low resistance to
abrasion.
If you notice the gasket becoming worn,
frayed or damaged in any way or if it
has become displaced on the door, you
should have it replaced.
To clean the inside of the door:
Because the area inside the gasket is
cleaned during the self-clean cycle, you
do not need to clean this by hand.
The area outside the gasket and the door
liner can be cleaned with a soap-filled
or plastic scouring pad, hot water and
detergent. Rinse well with a vinegar and
water solution.
To clean the outside of the door:
Use soap and water to thoroughly clean
the top, sides and front of the oven door.
Rinse well. You may also use a glass
cleaner to clean the glass on the outside
of the door. Do not let water drip into the
vent openings.
If any stain on the door vent trim is
persistent, use a soft abrasive cleaner and
a sponge-scrubber for best results.
Spillage of marinades, fruit juices, tomato
sauces and basting materials containing
acids may cause discoloration and should
be wiped up immediately. When surface is
cool, clean and rinse.
Do not use oven cleaners, cleaning
powders or harsh abrasives on the
outside of the door.
Care and cleaning of the cooking center.
The door is very heavy. Be careful when
removing and lifting the door.
Do not lift the door by the handle.
To remove the door:
Fully open the door.
Pull the hinge locks down toward the
door frame, to the unlocked position. A
tool, such as a small flat-blade
screwdriver, may be required.
Firmly grasp both sides of the door at
the top.
Close door to the door removal position
(see illustration).
Lift door up and out until the hinge arm
is clear of the slot.
To replace the door:
Firmly grasp both sides of the door at
the top.
With the door
at the same
angle as the
removal
position, seat
the indentation of the
hinge arm into the
bottom edge of the
hinge slot. The notch
in the hinge arm must be fully seated
into the bottom of the slot.
Fully open the door. If the door will not
fully open, the indentation is not seated
correctly in the bottom edge of the slot.
Push the hinge locks up against the
front frame of the oven cavity, to the
locked position.
Close the oven door.
Lift-Off Oven Door
Removal position
Hinge
arm
Bottom
edge of
slot
Hinge lock
Slot
Pull hinge locks down to unlock
Hinge
lock
Hinge
arm
Push hinge locks up to lock
40
Indentation
Loading ...
Loading ...
Loading ...