Loading ...
Loading ...
Loading ...
en
Use
8. Insert the power supply unit into the
the pump starts the initial watering.
The germination phase has begun and your
plants can grow.
Height modules
9.
module module onto the connector unit
of the pump and then place the light
guide slot when doing so.
Add another height module when the
plants have almost reached the light
unit.
the nutrient solution level is low. Once the
nutrient solution is used up, this is indicated
MSGP6: The light unit lights up white and
MSGP3
Note:
5 minutes until nutrient solution is topped
up.
level.
Mix the nutrient solution and add it at
Important:
amount (see 2.)! If the nutrient solution is
maximum capacity has been reached. Do
into the tray directly.
Harvesting
10. Harvesting can begin as soon as the
plants are big enough.
Note: Get further information from the
After the harvest is completed, it is
essential to clean all parts thoroughly
and descale them if required.
X
Setting sleep mode
The device automatically enters
be set.
11. MSGP6: Hold your hand on the light
2 times.
MSGP3: Press the button on the
underside of the light unit for 3 seconds
The start time for sleep mode is saved and
is retained until it is changed again.
Note: The sleep mode should begin in the
evening so as to allow the plants a chance
that the bright lighting will not disturb you
(e.g. if the appliance is in a bedroom).
Using holiday mode
In holiday mode, the plants grow
slower and use less of the nutrient
solution.
Note:
installed height modules.
it to maximum capacity if necessary.
12. MSGP6: Hold your hand on the light unit
purple.
MSGP3: Press the button on the
until the light lights up purple.
To end holiday mode, move your hand
over the light unit (MSGP6) or
press the button on the underside of the
light unit (MSGP3).
Icon 2
Sleep
Icon 3
Holiday
Loading ...
Loading ...
Loading ...