Loading ...
Loading ...
Loading ...
21
Troubleshooting
Before calling the customer service,
check whether you can rectify the
fault yourself by means of the
following table.
If a fault cannot be rectified or a
repair is required:
1. Set program selector to Off.
2. Turn off the circuit breaker.
3. Pull the mains plug out of the
socket.
4. Call customer service
(see page 22).
WARNING!
RISK OF ELECTRICAL SHOCK !
EXPLOSION HAZARD!
Repairs or replacement of parts
may be carried out by authorized
technicians only.
Problem Possible cause Remedial action
Dryer does not start.
Start/Stop indicator light does not
illuminate.
Main plug not inserted at all or not inserted correctly. Insert main plug correctly.
A fuse of power supply has tripped. Replace/switch on fuse.
Start/Stop button not pressed. Press Start/Stop button.
Door not closed. Close door.
Ambient temperature below 41 °F/5 °C. Increase room temperature.
Program has been interrupted. Filter
indicator light illuminates, awarning
signal is emitted and the display
shows "F:01" or "F:02".
Lint filter dirty. Clean filter as described on page 19.
Switch off/switch on again.
Exhaust air duct is blocked or too long. Clean exhaust air duct. Reduce exhaust air duct to
maximum length as described on page 11.
Switch off/switch on again.
Fault in program sequence or malfunction. Switch off dryer, leave to cool down for 30 min,
switch on again. Restart program.
The room/cabinet is not adequately ventilated. Provide an adequate supply of fresh air.
Switch off/switch on again.
Start/Stop indicator light does not
illuminate. Wrinkle block/Finished
indicator lights.
The display shows "–0–".
Fault in program sequence or malfunction. Switch off dryer, leave to cool down for 30 min,
switch on again. Restart program.
Degree of drying has not been
reached or the drying time is too long.
Display may indicate "F:04".
Moisture sensor dirty. Clean moisture sensor as described on page 20.
Switch off/switch on again.
Exhaust air duct is blocked or too long. Clean exhaust air extraction. Reduce exhaust air duct
to maximum length as described on page 11.
Switch off/switch on again.
Laundry was too wet. Spin laundry at higher speed in the washing machine.
Switch off/switch on again.
Unsuitable program selected. Select program with aid of the program selection
table (see page 26). Switch off/switch on again.
Maximum drying time was exceeded. Clean lint filter (see page 19).
Spin laundry at a higher speed in your washer.
Motor limit temperature was exceeded. Switch off dryer, leave to cool down for 30 min.
Switch on again. Start program.
Loading ...
Loading ...
Loading ...