Loading ...
Loading ...
Loading ...
12
Installation –
step by step
1. Unpack the dryer.
2. Remove all objects from the
drum.
3. Check the dryer for visible
damage.
4. Position the dryer near the
installation location.
If space is very restricted, it is
recommended to fit the
exhaust air duct to the dryer
before the dryer is moved to
its final installation location.
5. Move the dryer to its final
location and align.
6. Position and then level the
dryer.
The dryer should be level with
all four feet firmly on the
ground. The dryer must not
wobble.
If the dryer is not level or if it
does wobble, the feet must be
adjusted. Adjust the
height-adjustable feet until the
dryer does not rock and is
level, both front-to-back and
side-to-side.
7. Insert plug into the wall
receptacle.
Check list before
using the dryer
1. Check that steps 1-7 have
been implemented properly.
2. Ensure that the dryer is
connected to the power
supply.
3. Read the operating
instructions to understand how
your dryer operates.
4. Conduct an appliance test:
Check that the drum is
empty.
Close the dryer door.
Switch the dryer to
Extra dry and then press
the Start button.
After 3-5 minutes press the
Stop button and open the
door.
5. If the interior of the dryer feels
warm, the dryer has been
connected properly. Switch
the dryer to Off.
6. If the dryer does not work,
switch the dryer to Off.
Look in the troubleshooting
section (page 21) of the
OPERATING INSTRUCTIONS
and find the fault.
Preparing to transport
the dryer
1. Rotate the program selector
to Off.
2. Pull out power supply plug.
3. Place any accessories in the
drum.
4. Close the door and secure
with adhesive tape.
5. Screw the height-adjustable
feet of the dryer into the
housing to prevent them from
being damaged during
transportation.
CAUTION
Do not slide dryer across the
floor if height-adjustable feet
have been extended. Feet and/
or dryer base may be damaged
if dryer is slid across floor with
height-adjustable feet extended.
Loading ...
Loading ...
Loading ...