Loading ...
Loading ...
Loading ...
18
Operation
Using the dryer
1. Open the door.
2. Check lint filter.
The filter should be cleaned
after and before every drying
process. Cleaning the filter
reduces the drying time and
saves energy.
3. Rotate program selector to the
desired program. Select the
program which corresponds to
the laundry in the dryer from
the program selection table
(see page 26).
The Start/Stop indicator light starts
flashing.
Lint filter indicator flashes for
5 seconds – Check lint filter!
4. If required, select Delicates
low temp. by pressing the
button.
See explanation on page 17.
5. Place laundry in the empty
drum. Put each piece of
laundry into the machine
separately.
For best results the laundry to
be dried must be sorted
according to type of laundry
and desired degree of drying.
For further information see
page 16.
Observe drying symbols of the
laundry manufacturer.
Ensure that there is only laundry in
the drum. Check that all items are
completely in the drum.
6. Close the door.
If the door has not been
closed properly, the dryer will
not start.
7. Press the Start/Stop button.
The Start/Stop indicator light
illuminates.
If an automatic program has been
selected, the indicator lights
indicate the progress of the
program sequence.
At the end of the program
sequence Damp dry is emitted
(if set).
At program end the LED
Wrinkle block/End illuminates.
When the drying process is
complete (program or
selected time program
ended), the drum rotates at
specific intervals. This prevent
the laundry from creasing.
8. Open the door.
9. Take the laundry out of the
dryer.
10. Rotate the program selector
to Off.
The dryer light goes out.
11. Clean the filter.
The filter should be cleaned
after each drying process.
Cleaning the filter reduces the
drying time and saves energy.
12. Close the door.
Loading ...
Loading ...
Loading ...