Loading ...
Loading ...
Loading ...
14
TROUBLESHOOTING
If you experience Possible Causes Solution
Dryer Results (cont.)
Load too hot Load removed before cool-down
portion of cycle complete.
Allow the dryer to complete the cool-down portion of the cycle
before removing the load.
Using Timed Dry cycle with a high
temperature setting.
Select an Sensor cycle with a lower heat setting to avoid
overdrying the load.
Dryer Displaying Code Message or Indicator Is Lit
“PF” (power failure) The drying cycle has been interrupted
by a power failure.
Touch the START/PAUSE button to clear the PF error message;
then touch and hold the START/PAUSE button to resume cycle.
“L2” Diagnostic code
(low or no line voltage
condition)
There may be a problem with your
home power supply, keeping the
dryer’s heater from turning on.
The dryer will continue to run when this diagnostic code is
present. Touch any pad to clear the code from the display and
return to the estimated time remaining.
Try the following:
n
Check to see if a household fuse has blown or circuit
breaker has tripped. Electric dryers use 2 household fuses or
breakers. Replace the fuse or reset the circuit breaker.
n
Conrm that the power cord is properly installed. Refer to
the Installation Instructions for details.
n
Select a Timed Dry heated cycle, and restart the dryer.
If the message persists, consult a qualied electrician.
“F# E#” (F1 E1, F3 E1,
etc.) variable service
codes
The dryer is in need of service. If a code beginning with an “F” appears in the display, alternating
between F# and E#, the dryer control has detected a problem
that requires service. Call for service.
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
to possibly avoid the cost of a service call.
Loading ...
Loading ...
Loading ...