Loading ...
Loading ...
Loading ...
5. Observe the headlight aim on the wall. The most intense part of the headlight
beam should be 5 cm below the mark on the wall
w
. Include rider weight on
the seat when measuring.
6. If adjustment is needed, the adjustment screw
q
is located on the right side
of the headlight pod. To adjust the beam, loosen the screw. Adjust the
headlamp to the desired position, then tighten the screw.
LOW BEAM ADJUSTMENT
The low beam can be adjusted slightly upward or downward.
1. Loosen the Phillips® screw located at the rear of the headlamp.
2. Tilt the headlamp upward or downward.
3. Tighten the screw.
LOWER HEADLAMP REPLACEMENT
1. Turn the back of the headlight harness counter-clockwise and pull the
harness assembly away from the headlight assembly.
2. Remove the headlamp and install the new headlamp.
3. Reinstall the harness assembly into the headlight assembly.
4. Turn the headlight harness clockwise to secure the headlamp.
q
Phillips Screw
w
Lamp
e
Harness
124
MAINTENANCE
Loading ...
Loading ...
Loading ...