Loading ...
Loading ...
Loading ...
15
Required Actions to prevent frost
(Water Removal in Water Tank and Evaporator)
• If the ambient temperature falls below 0°C/32
o
F, water will freeze inside the machine and machine
operation will be impossible.
• If you do not use for a long period of time in winter, be sure to completely remove the ice making
water inside the body by following the instructions below. If you do not remove the ice making water
or if it is insufficient, it will cause serious damage to the product. This shall not be guaranteed by the
manufacturer and may result in a lot of repair costs. Please observe the following points.
1. Turn on the power switch and press the DOWN + SET
button at the same time for 3 seconds with any signal
on the FND window. Forced drainage will be done for
30 seconds.
2. Turn off the power switch and disconnect the power
plug from the outlet.
3. Remove the upper panel → the front panel.
4. Remove the evaporator cylinder drain hose clamp and
remove the hose, and wait until the ice in the
evaporator cylinder completely melts down. It is
possible to remove internal water quickly by using
compressed air gun etc.
5. Reassemble the evaporator cylinder drain hose and tighten the clamp.
6. Assemble in the order of left panel → upper panel → front panel.
Maintenance, repair and disinfection
※ Please keep the product according to the instruction manual and label provided.
● Be sure to have a qualified service technician service the product.
● To reduce the risk of electric shock, do not touch or disassemble the parts of the ice maker.
● Before service
- Turn off the power switch of the dispenser and the earth leakage breaker, and disconnect the power
plug from the outlet.
● Choking hazard - After performing maintenance and repair, make sure that all components (such as
fixtures, screws, bolts, etc.) are completely assembled.
- Be careful not to let any components fall into the ice making compartment and ice reservoir.
Loading ...
Loading ...
Loading ...