Loading ...
Loading ...
Loading ...
9ENGLISH
Before rst use
1 Thoroughly clean the skewer parts and the metal frame with hot soapy water
and a non-abrasive sponge or in the dishwasher before you use the rotisserie
for the rst time.
2 To insert the batteries (two D-cell batteries) into the motor unit, push to open
the battery compartment.
Note:
- Before inserting batteries into the battery compartment of the equipment, the
contacts of both equipment and batteries should be checked for cleanliness
and correct positioning.
- If necessary, clean with a damp cloth and dry before inserting.
- It is of extreme importance that batteries are inserted correctly with regard to
polarity (+ and –).
- Follow equipment instructions carefully and use the recommended batteries.
- Failure to follow the instructions, which should be available with the
equipment, can result in malfunction and damage of the equipment and/or
batteries.
- It is advantageous to remove batteries immediately from equipment which has
ceased to function satisfactorily, or when not in use for a long period.
- Be sure to switch o the equipment after use.
- Store batteries in a cool, dry place and out of direct sunlight.
- Batteries which have been cold-stored should be put into use as soon as
possible after return to ambient temperature.
- Replace all batteries of a set at the same time. Newly purchased batteries
should not be mixed with partially exhausted ones. Batteries of dierent
electrochemical systems, grades or brands should not be mixed.
- Failure to observe these precautions may result in some batteries in a set being
driven beyond their normal exhaustion point and thus increase the probability
of leakage.
3 Screw the two spit rod parts together and x the handle by screwing it on the
spit rod (Fig. 2).
Using the appliance
1 Unfold the metal frame until all four walls are stable and opposite sides are
parallel (Fig. 3).
2 Attach the frame onto the base of the grill (Fig. 4).
3 Attach the motor unit on the frame (Fig. 5). Be sure to align the two guiding slots
to slide the motor unit securely onto the frame.
4 Slide the screw end of the bearing part along the spit rod to the handle (Fig. 6).
To check proper placement, put the end of the spit rod into the hole of the
motor unit and the spit rod into the metal frame recesses. The rounding section
of the bearing part should t exactly in the opening of the frame to allow the
rod to turn freely. Turn the screw to securely x the bearing part in place on the
spit rod (Fig. 7).
Loading ...
Loading ...
Loading ...