Loading ...
Loading ...
Loading ...
General Care & Cleaning
FEATURE OVERVIEW
• Removing & Replacing the External Door Glass Panel
• Removing &Replacing Warmer Drawer
Removing and Replacing the External Door Glass Panel
Applicable only to models with an external glass panel not held with frame. This design allows you to clean the inside
face of the exterior door panel as well as the hidden face of the door inner glass.
To Remove the External Door Glass Panel:
1. Remove the door as described in Removing and Replacing the Oven Door section and lay the door flat.
2. Using a screwdreiver, remove the 5 screws fastening the glass & molding assembly.
3. Grasp both sides of the glass panel and slowly pull it out of the door upper molding. Lay the glass flat.
To Replace the External Door Glass Panel:
1. Grasp the sides of the glass panel carefully insert the glass into the door top molding.
2. Replace the 5 locking screws.
3. Replace the door onto the range.
Handle the glass panel with care. When dropped on a corner, the glass panel may shatter. This can cause Z
several persona injury.
Push down latch
with finger
Figure 1
Right Glide
Figure 2
Removing and Replacing Warmer (Warm & Ready TM) Drawer z
To Remove Warmer Drawer:
1. _['_ Turn power off before removing the warmer drawer.
2. Open the drawer to the fully opened position.
3. Locate glide lever on each side of drawer, pull up on the left glide lever
and push down on the right glide lever (See Figure 1).
5. Pull the drawer away from the range.
To Replace Warmer (Warm & Ready TM) Drawer:
1. Pull the bearing glides to the front of the chassis glide (See Figure 2).
2. Align the glide on each side of the drawer with the glide slots on the
range.
3. Push the drawer into the range until levers "click" (approximately 2"). Pull
the drawer open again to seat bearing glides into position. If you do not
hear the levers "click" or the bearing glides do not feel seated
remove the drawer and repeat steps 1 thru 3. This will minimize
possible damage to the bearing glides.
NOTE: The Warmer Drawer will NOT operate while inthe "Self-Clean" and "Oven
Lockout" modes
_1 _ Electrical Shock Hazard can occur and result
in serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the warmer drawer.
33
Loading ...
Loading ...
Loading ...