85X6US User Manual

Loading ...

3. Connect the outside aerial or cable network to the Antenna input socket at

the back of the TV set.

The aerial socket (75 OHM - VHF / UHF / cable) can be used for connecting

anexternalaerialorotherequipmentttedwithamodulator(videorecorder,

satellite receiver, etc.). We recommend that you do not connect other

equipment (video recorder, satellite receiver, etc.) to your TV set to begin

with, so as not to complicate the set-up procedure with the additional steps

 involved.Connectthemwhenyouhavenishedsettingupthechannels.

4. When powered on, the TV will be turned on directly or be in standby mode.

If the TV set is in standby mode, press the standby button on the remote

control or on the TV set to turn on the TV.

Note: The location and name of the power button on the TV may vary

according to TV model.

Connections and Setup

Switching off

To put the TV set into standby mode, press on the remote control or on the TV, the TV set remains powered up,

but with low energy consumption.

To switch off the TV set, disconnect the mains plug from the mains outlet.

Switching on

Follow the instructions on this page on how to switch on your TV set and the remote control before going on to follow-

ing pages describing how to use the channel set-up procedure.

1. Insert two AAA batteries in the remote control.

Precautions on using batteries:

-Onlyusethebatterytypesspecied.

- Make sure you use the correct polarity.

- Do not mix new and used batteries.

- Do not use rechargeable batteries.

-Donotexposebatteriestoexcessiveheatsuchassunshine,reorsimilar,throwtheminare,rechargethem

or try to open them, as this could cause them to leak or explode.

- Remove the batteries from the remote control if you are not using it for a long period of time.

- Attention should be drawn to the environmental aspects of battery disposal.

2.Connectthepowercabletoamainssocket.(Ifthepowercableisnotconnectedtothetelevision,pleaserst

connectthepowercabletothetelevision.)YourTVsetshouldonlybeconnectedtoanACsupply.Itmustnotbe

connected to a DC supply. If the plug is detached from the cable, do not, under any circumstances, connect it to a

mains socket, as there is a risk of electric shock.

Note: The gures are for representation only. The location of the power socket at the back of the television might

differ depending on the model.

Loading ...

User Manual - Page 11