Loading ...
Loading ...
Loading ...
13
If you experience Possible Causes Solution
Washer Not Performing As Expected (cont.)
Washer won’t run or ll,
washer stops working, or
wash light remains on
(indicating that the washer
was unable to ll
appropriately)
Check for proper water supply.
Both hoses must be attached and have water owing to inlet valve.
Both hot and cold water faucets must be turned on.
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hoses, which can restrict water ow.
Washer won’t run or ll,
washer stops working, or
wash light remains on
(indicating that the washer
was unable to ll
appropriately) (cont.)
Check proper electrical supply. Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Normal washer operation. Lid must be closed for washer to run.
Washer will pause during certain phases of cycle. Do not interrupt cycle.
Washer may be tightly packed. Remove several items, rearrange load evenly in basket. Close lid and
press START/PAUSE/Unlock Lid.
Do not add more than one or two additional items after cycle has started
to avoid tightly packing or unbalancing.
Do not add more water to the washer.
Washer not draining/
spinning, loads are still wet,
or spin light remains on
(indicating that the washer
was unable to pump out
water within 10 minutes)
Small items may have been caught in
pump or between basket and tub, which
can slow draining.
Empty pockets and use garment bags for small items.
Use a cycle with a low spin speed. Cycles with lower spin speeds remove less water than cycles with high
spin speeds. Use the recommended cycle/spin speed for your garment.
To remove extra water in the load, select Drain/Spin. Load may need
to be rearranged to allow even distribution of the load in the basket.
The washer may be tightly packed
or unbalanced.
Tightly packed or unbalanced loads may not allow the washerto spin
correctly, leaving the load wetter than normal. Evenly arrange the wet
load for balanced spinning. Select the Drain/Spin cycle to remove excess
water. See the “Using Your Washer” section for loading recommendations.
Check plumbing for correct drain hose
installation. Drain hose extends into stand-
pipe farther than 4.5” (114 mm).
Check drain hose for proper installation. Use drain hose form and
securely attach to drainpipe or tub. Do not tape over drain opening.
Lower drain hose if the end is higher than 96” (2.4 m) above the oor.
Remove any clogs from drain hose.
Too much detergent causing suds to slow
or stop draining and spinning.
Always measure and follow detergent directions for your load. To remove
extra suds, select Rinse/Spin. Do not add detergent.
Dry spots on load
after cycle
High speed spins extract more
moisture than your previous washer.
The high spin speeds combined with air ow during the nal spin can
cause items near the top of the load to develop dry spots during the nal
spin. This is normal.
Loading ...
Loading ...
Loading ...