Loading ...
Loading ...
Loading ...
18
If the door falls open, increase the spring tension by moving
the spring end toward the back of the dishwasher.
NOTE: Springs should be in the same notches on left and
right sides.
Align front of dishwasher door panel with front of cabinet
doors. You may need to adjust alignment to be even with
your cabinets.
Check that leveling legs are firmly against the floor. Close and
latch the door and place level against the front panel. Check
that dishwasher is centered from front to back in the opening.
If needed, adjust leveling leg until dishwasher is plumb. Repeat
for other side of dishwasher.
Helpful Tip: Push up on front of dishwasher to raise dishwasher
off the ground to adjust front legs. With some installations, it
may be easier to adjust the front leg using a
3
/
16
" hex head
socket or adjustable wrench. If the gap between the top of the
door and the underside of the counter top is tight (less than
1
/
4
" [6 mm]), we suggest side anchoring to keep from scratching
the User Interface or console.
41. Door falls open –
increase spring tension
42. Align front of dishwasher
with front of cabinet doors
43. Check for plumb and
adjust legs if needed
Push bracket into slot on the side of dishwasher and bend
tab in toward the side of the dishwasher so that it keeps
the bracket in place. Repeat this step for the other side of
the dishwasher.
NOTE: Install wood shims to the inside of the cabinets if the
gap between the sides of the cabinet and the sides of the
dishwasher are greater than
1
/
2
" (13 mm) on each side.
NOTE: Do not attach the dishwasher. This will be done later.
FINAL INSTALLATION CHECK
If the door closes too quickly, decrease the spring tension by
moving the spring end toward the front of the dishwasher.
NOTE: Springs should be in the same notches on left and
right sides.
38. Install bracket
Bend
tabs
39. Open and close door
40. Closes too quickly –
decrease spring tension
Loading ...
Loading ...
Loading ...