Loading ...
Loading ...
Loading ...
14
DRAIN HOSE CONNECTION
Place towel under drain hose to catch any water in drain hose.
Place the small (green) drain hose clamp onto the small end
of the drain hose. Push the new drain hose into the rubber
drain hose connector up to the drain hose stop.
Using pliers, squeeze open the small drain hose clamp,
and slide it onto the connector between stops.
NOTE: Route drain hose out the rear of the dishwasher.
19. Connect drain hose
Stop
Stop
Drain hose stop
Drain hose
Rubber drain hose
connector
Small clamp
20. Slide clamp onto connector
Stop
Stop
Drain hose stop
Drain hose
Rubber drain hose
connector
Small clamp
21. Hose clamp final position
Stop
Stop
Drain hose stop
Drain hose
Rubber drain hose
connector
Small clamp
POWER CORD CONNECTION
NOTE: If removing a previous dishwasher with a power cord,
you will need to transfer the power cord to the new dishwasher.
Using a
1
/
4
" hex-head socket, nut driver, or Torx
®
T20
®
screwdriver, remove terminal box cover. Retain for later use.
Install a UL Listed/CSA Approved metallic strain relief.
Make sure screw heads are facing to the left when tightening
conduit nut. Strain relief is provided with the power cord
kit. See the “Tools and Parts” section at the front of the
guide for part details and orders.
Route cord so that it does not touch dishwasher motor or
lower part of dishwasher tub. Pull cord through strain relief
in terminal box.
NOTE: A maximum of 2 power cord supply conductors (12 AWG
largest size) plus 1 grounding conductor are permitted in the
terminal box.
22. Remove terminal box cover
23. Install strain relief
24. Power cord – route cord
into terminal box
Loading ...
Loading ...
Loading ...