Loading ...
Loading ...
Loading ...
13INSTALLATION
ENGLISH
Choosing the Proper
Location
Install the washer on a solid oor that is strong and
rigid enough to support the weight of the washer,
even when fully loaded, without exing or bouncing.
If the oor has too much ex, you may need to
reinforce it to make it more rigid. If the oor is not
solid, it may cause severe vibration and noise.
NOTE
• Before installing the washer, make sure the oor
is clean, dry and free of dust, dirt, water and oil so
the washer feet cannot slide easily. Leveling feet
that can move or slide on the oor can contribute to
excess vibration and noise due to poor contact with
the oor.
• If a drip pan must be used, take extra care to follow
the instructions provided with the drip pan and make
sure the leveling feet are adjusted for rm and even
contact with the pan. Use of drip pans and failure to
properly level the machine may result in increased
vibration and noise during operation.
• Allow for sufcient space between the walls and the
washer for installation.
• If the appliance is installed in an area where the
temperature is above or below the recommended
operating temperature range, it may result in longer
drying times or poor drying performance.
Power Outlet
• The power outlet must be within 60 inches (1.5 m)
of either side of the washer.
• The appliance and outlet must be positioned so that
the plug is easily accessible.
• Do not overload the outlet with more than one
appliance.
• The outlet must be grounded in accordance with
current electrical wiring codes and regulations.
• Use a time-delay fuse or circuit breaker.
NOTE
• It is the personal responsibility and obligation of the
product owner to have a proper outlet installed by
qualied service personnel.
Flooring
• To minimize noise and vibration, the washer must
be installed on a solidly constructed oor.
NOTE
• The washer must be installed on rm ooring to
minimize vibration during the spin cycle. Concrete
ooring is best, but a wood oor is sufcient,
provided it is built to FHA standards.
Floor Installation
1"1"4"
1"
53 / "
1
8
48 / "
1
2
49 / "
1
4
42 / "
1
8
* 49 / "
1
4
23 / "
5
8
0.2"
• To minimize noise and vibration, the washer must
be installed on a solidly constructed oor.
NOTE
• Refer to the instructions packaged with the optional
pedestal kit before installing with a pedestal kit.
Unpacking and Removing
Shipping Bolts
1
Lift the washer off the foam base.
After removing the carton and shipping material,
lift the washer off the foam base. Make sure the
plastic tub support comes off with the base and
is not stuck to the bottom of the washer.
If you must lay the washer down to remove the
base packaging materials, always protect the
side of the washer and lay it carefully on its side.
Do not lay the washer on its front or back.
Foam tub
support
Carton base
2
Remove the bolt assemblies.
Starting with the bottom two shipping bolts, use
the wrench (included) to fully loosen all four
shipping bolts by turning them counterclockwise.
Remove the bolt assemblies by wiggling them
slightly while pulling them out.
Shipping
bolt
NOTE
• Save the bolt assemblies for future use. To prevent
damage to internal components, do not transport
the washer without reinstalling the shipping bolts.
• Failure to remove shipping bolts and retainers may
cause severe vibration and noise, which can lead
to permanent damage to the washer. The cord is
secured to the back of the washer with a shipping
bolt to help prevent operation with shipping bolts in
place.
Loading ...
Loading ...
Loading ...