Loading ...
Loading ...
Loading ...
Operating the Dishwasher en-us
43
1 Operating the
Dishwasher
Oper at i ng the Di s h wa s h e r
Note: With hidden controls, the door
must be opened before changing
settings and closed after changing
settings.
9 WARNING
RISK OF INJURY!
To avoid risk of injury, always
use caution when opening the
door during or following a wash
cycle as hot water or steam
may escape. Do not fully open
the door until water noises have
stopped and steam has
subsided.
Protection against
unintentional operation
Your dishwasher is equipped with a
function that helps to prevent
unintentional operation (e.g. by
children).
After starting the dishwasher, the
dishwasher door has to be closed
within 4 seconds, otherwise the
operation will be paused. There will
be a signal on the control panel
advising you to press the Start button
again and close the door.
This function will be activated when:
■ pressing Start to begin a wash
cycle
■ setting Delay time and pressing
Start
■ opening the door while Delay time
is active
■ opening the door during a wash
cycle.
Note: This function cannot be
deactivated.
Operating the touch buttons
Buttons are sensitive and should be
touched gently. Avoid any grease or
food particles resting on the buttons
as they could activate the
dishwasher.
Wiping and cleaning can also
activate the dishwasher. For best
results, use bare, clean hands when
touching the buttons.
To clean the touch buttons wipe them
with a dry or slightly damp cloth.
Changing the settings
The dishwasher has been preset with
certain settings for your convenience.
You can change these factory
settings.
Change the setting as follows:
1.
Open the door.
2.
Switch on On/Off button (.
3.
Press Info button 8 for
3 seconds until the following text
is indicated in the digital display
@:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
4.
Keep pressing button > ` until
the required setting is indicated in
the display window at the top
@.
5.
Make the selection with setting
buttons + -X.
6.
Press and hold the Info button
8 for 3 seconds.
The chosen setting has now been
stored.
Tip: If you change several settings,
first make all changes in succession.
Now press the Info button 8 for
3 seconds. This saves all set values
in the appliance.
Loading ...
Loading ...
Loading ...