Loading ...
Loading ...
Loading ...
10
Using the Dispensers
1. For automatic dispensing, open the bulk dispenser drawer
using the handle at the base of the washer. For a single load,
open the single-load dispenser drawer at the top left corner
of the washer and disable the Load & Go
™
option.
2. Add laundry products as described below.
3. Slowly close the dispenser drawer. Make sure it is
completely closed.
NOTES:
■
A small amount of water may remain in the single load
dispenser from the previous wash cycle. This is normal.
■
See “About Detergent Concentration” for information on
detergent concentration.
■
When detergent in the bulk dispenser is running low, the
display will show the detergent level (Low).
■
Add single-dose and Oxi-type boosters to the drum before
loading items. See the “Using Your Washer” section.
Adding HE detergent to dispenser
Powdered detergent:
Lift the selector to the high
position. Add directly to the
compartment.
Load & Go
™
bulk dispenser
Adding detergent for a single load
IMPORTANT:
■ Disable Load & Go
™
dispenser(s) as desired (see Step
11 in “Using Your Washer”).
■ Do not add single-dose laundry packet to dispenser
drawer.
HE detergent
compartment
Use only High
Efciency (HE)
detergent.
Liquid detergent:
Push down the selector
to the low position. Add
directly to the compartment.
Use only High Efciency (HE)
liquid detergents. The bulk dispensers
will hold about 67.6 oz (2 L) or
33.8 oz (1 L) of liquid HE
detergent, depending on dispenser,
or enough for many loads of laundry.
To Fill Bulk Dispeners:
Open the dispenser drawer by pulling on the handle at the
base of the washer. If desired, the bulk dispensers can be
completely removed from the drawer.
Locate the Load & Go
™
bulk
dispenser. Gently pull up on the
tab located on the bulk dispenser
lid to lift the ll door.
Fill to the “MAX” line (see
illustrations at right) with HE
liquid detergent or liquid fabric
softener (1-liter dispenser only).
Close ll door. It will click into place.
Make sure the concentration setting
is correct (see the “Choosing the
Right Detergent” section).
It is recommended that you rinse
out the Load & Go
™
containers when
relling, when changing detergent
types or concentrations, or when
the washer will not be used for an
extended period.
For instructions
on cleaning the dispenser cartridge,
see the “Washer Care” section.
For instructions on changing
detergent concentration, see
“Using Your Washer, Step 11.
Use only High Efciency
(HE) detergent.
Selector
Pour a measured amount of HE detergent into detergent
compartment. For powdered detergent, lift the selector
to the high position. For liquid detergent, push down the
selector to the low position.
Do not overll; adding too much detergent may cause
detergent to be dispensed into the washer too early.
“MAX” line
Tab
Loading ...
Loading ...
Loading ...