Loading ...
Loading ...
Loading ...
43
EN
Advanced Settings
Registration
The procedures described below are the procedures that you will find in your SE435 handset. The procedures
may vary according to the handset you want to register. In this case, please refer to the manufacturer of the
additional handset.
Additional handsets must be registered to the base unit before you can use them. Up to 5 handsets can be
registered to one base station.
To register an additional handset
1. On the base station, press and hold c key for 3 seconds in stand-by mode. After that, the registration
procedure has to be done within 1 minute.
2. At the same time, on the handset, press
m, scroll : to Advanced Set and press OK, scroll : to
Registration and press
OK.
3. Enter the Master PIN when prompted and press
OK to start registration.
A long confirmation tone is emitted to indicate successful registration and the screen returns to previous
menu.
Unregister
To unregister a handset
1. Press m, scroll : to Advanced Set and press OK, scroll : to Unregister and press OK.
2. Enter the Master PIN when prompted and press
OK to confirm.
3. Press on the handset keypad the handset number corresponding to the handset that you wish to
unregister.
A long confirmation beep is emitted to indicate successful unregistration and the screen shows
Unregistered.
The Master PIN is required before you can register or unregister handsets. The default PIN is 0000.
Within 1 minute, the base station is able to accept registration from a handset. If no key is pressed
within 10 seconds, the registration procedure will be aborted.
If the base is found and the PIN is correct, the unused handset numbers will be shown and you can
select a handset number by entering the number directly.
If the PIN is incorrect, Incorrect PIN will be displayed and the handset returns to stand-by mode.
If there are no key presses within 15 seconds, the unregistration procedure will be aborted and the
handset returns to previous menu.
Loading ...
Loading ...
Loading ...