Loading ...
Loading ...
Loading ...
English 21
Installation
4. Attach the water hoses to the hot and
cold water inlets on the back of the
washer, and then hand tighten the
water hose ttings until they are tight.
Then, use pliers to tighten the ttings
by an additional two-thirds of a turn.
NOTE
• If you are not going to use the hot
water, block the hot water supply
intake with the water intake cap.
Otherwise, there is a risk of water leak.
• Make sure to set the water temperature
to Cold after blocking the hot water
supply intake. Otherwise, the amount
of supplied water could be low, or the
water could not supply at all.
5. Open the water taps, and check for
leaks.
Untitled-23 21 2020-03-02 PM 2:00:32
Loading ...
Loading ...
Loading ...