Loading ...
Loading ...
Loading ...
Installation
English16
Installation
Installation requirements
Electrical supply and grounding
AC 120 V / 60 Hz / 15 AMP fuse or circuit breaker is required.
Use an individual branch circuit. Connect only the washer to the circuit.
To ensure proper grounding, the washer comes with a power cord featuring a three-prong
grounding plug for use in a properly installed and grounded outlet.
Check with a qualied electrician or service person if you are not sure about the
grounding.
Do not modify the provided plug. If it does not t the outlet, call a qualied electrician to
install a proper outlet.
WARNING
Do NOT use an extension cord.
Use only the power cord that comes with the washer.
Do NOT connect the ground wire to plastic plumbing, gas lines, or hot water pipes.
Improperly connected grounding conductors may cause electric shock.
To prevent unnecessary risk of re, electrical shock, or personal injury, all wiring
and grounding must be done in accordance with local codes, or in the absence of
local codes, in accordance with the National Electrical Code, ANSI/NFPA No. 70-Latest
Revision (for the U.S.) or the Canadian Electrical Code CSA C22.1 – Latest Revisions
and local codes and ordinances. It is your responsibility to provide adequate electrical
service for your washer.
Water supply
Proper water pressure for this washer is between 20-116 psi (137-800 kPa). Water
pressure less than 20 psi (137 kPa) may cause the water valve not to close completely.
or it may take longer to ll the drum, causing the washer to turn off. Water taps must be
within 4 ft. (122 cm) from the rear of the washer so that the provided inlet hoses reach
the washer.
To reduce the risk of leaks:
Make sure water taps are easily accessible.
Turn off the taps when the washer is not in use.
Check for any leaks at the water inlet hose ttings on a regular basis.
CAUTION
Before using the washer for the rst time, check all connections at the water valve and
taps for any leaks.
Untitled-23 16 2020-03-02 PM 2:00:30
Loading ...
Loading ...
Loading ...