Loading ...
Loading ...
Loading ...
Error code failure system
If your appliance senses that it is not operating correctly, then An
error code will appear on the control panel.
The following error codes can possibly be remedied by the customer
and the steps outlined below should be followed.
BEFORE COMPLETING ANY MAINTAINEANCE ON THE
APPLIANCE, IT SHOULD BE DISCONNECTED FROM YOUR MAINS
POWER SUPPLY.
E-1
o Longer than expected fill time.
Check the water pressure of your mains water supply.
Clean the mesh filter that sits in the inlet hose.
Ensure that the inlet hose is not kinked or crushed.
Make sure the water tap that the machine is connected to is turned
on fully.
E-2
o The machine has sensed water in the base.
Check that the outlet hose is not kinked or crushed.
Check that there are no blockages in the drain hose or the drainage
system that the appliance is connected to.
The drain pipe may be placed in too high a position or incorrectly.
Check the installation instructions and ensure that the installation is
correct.
o Once you have taken action to rectify the problem that has
caused the fault code to appear, plug the machine back into your
mains power supply.
o Turn the machine on using the ON/OFF button and wait for 5
seconds.
o Wait for a further 5 seconds before attempting to set a wash
program, using the program selection button.
IMPORTANT: If any other fault code appears in the display
window, you should not attempt to clear it yourself and contact
the Customer Care Department.
29
Loading ...
Loading ...
Loading ...