Loading ...
Loading ...
Loading ...
English 11
Range Hood Care
Range Hood Use
Range Hood Care
Performance (CFM) Conversion
• Press and hold the HIGH and BOOST button on the hood for 3
seconds to convert Blower performance.
• Normal mode:
appears in the display. The blower will operate
normally (Max 390 CFM).
• Power mode:
appears in the display. The blower will operate
powerfully (Max 600 CFM).
CAUTION
• Do not activate this function without qualied person.
We recommend that a qualied technician install the range hood.
It is the installer’s responsibility to ensure the range hood complies
with the installation clearances specied for the product.
To activate Power mode of this function, the Make-up air system is
required.
Range Hood Care
Cleaning
IMPORTANT: Clean the hood and bafe lters frequently according to the
following instructions. Replace the bafe lters before operating the hood.
Exterior Surfaces:
To avoid damage to the exterior surface, do not use steel wool or soap-
lled scouring pads to clean the hood.
Always wipe dry to avoid water marks.
Cleaning Method:
• Liquid detergent soap and water or all-purpose cleanser
• Wipe with a damp soft cloth or nonabrasive sponge, then rinse
with clean water and wipe dry.
• Do not use cleaning agents containing bleach.
Stainless Steel Bafe Filter:
1. Remove the lter by pulling the spring release handle, and
then pulling down the lter.
A
A. Spring release handle
Makeup Air
• When using ventilation systems with greater than specied CFM of
air movement, review local building codes as they may require
makeup air systems. Consult a HVAC professional for specic
requirements for you’re area as CFM requirements can vary between
locales.
• Consult a HVAC professional to select the correct CFM capacity
range hood for your application. The CFM capacity depends on the
range or cooktop BTU rating, size and location, size of the kitchen
and the range hood ductwork in the kitchen.
2. Wash the stainless steel bafe lter as needed in your dishwasher
or a hot detergent solution.
3. To reinstall the lter, rst make sure the spring release handles are
toward the front. Insert the stainless steel lter into the
upper track.
4. Push in the spring release handle.
5. Push up on the stainless steel lter, and then release the handle to
latch the lter into place.
WARNING
When removing the lter, please hold it with both hands to make sure it
does not fall.
Replacing an LED Lamp
The LED lights are replaceable by a service technician only. See the
support contact information in the Warranty section.
Replacing the charcoal lter
After approximately one year of use, the charcoal lter should be re-
placed with a new one, as the odour reduction capacity will be reduced.
NOTE
Charcoal lters are not included with the hood. They must be ordered
from your supplier or Samsung service center.
Order the needed kit specifying your hood model and width size.
Loading ...
Loading ...
Loading ...