Loading ...
Loading ...
Loading ...
20
2. Access the menu as described in section "6.1 Access the
settings menu";
3. Press "WATER FILTER"; "TURN DATE INDICATOR TO NEXT 2
MONTHS" (g. 37): turn the date disk to display the next
2 months of use.
4. Press
;
37 38
Please note
The lter lasts about two months if the machine is used normal-
ly. If the coee machine is left unused with the lter installed, it
will last a maximum of 3 weeks.
5. "RUN WATER INTO FILTER HOLE" "UNTIL IT COMES OUT" (g.
38): To activate the lter, run tap water through the hole
in the lter as shown in the gure until water comes out
of the openings at the side for more than a minute. Press
;
6. Extract the tank (A17) from the machine and ll with
water.
7. "IMMERSE FILTER TO" "EXPEL AIR BUBBLES" (g. 39): Insert
the lter in the water tank and immerse it completely for
about ten seconds, sloping it and pressing it lightly to ena-
ble the air bubbles to escape. Press
;
39
3939
8. "INSERT FILTER" "IN HOUSING": Insert the lter (D4) in the
lter housing (g. 36) and press as far as it will go. Press
;
9. "INSERT WATER TANK": Close the tank with the lid (A17),
then put the tank back in the machine (g. 5);
10. "POSITION 0.5L CONTAINER" "OK TO ENABLE FILTER"
(g. 7): Place the container under the hot water spout
(D6) and press
. Delivery begins and stops
automatically.
The lter is now active and the coee machine can be used.
17.2 Replacing the lter
Replace the lter (D4) when "REPLACE WATER FILTER" "PRESS
OK TO START" appears on the display: to replace immediately,
press
and follow the instructions from point 5.
To replace the lter later, press
. The sym-
bol appears on the display to remind you that the lter needs
replacing. To replace, proceed as follows:
1. Extract the tank (A17) and exhausted lter;
2. Remove the new lter from the packaging;
3. Access the menu as described in section "6.1 Access the
settings menu";
4. Follow the operations described in the previous section
from point 3.
The lter is now active and the coee machine can be used.
Please note:
After two months (see date indicator) or when the machine has
not been used for 3 weeks, you should replace the lter even if
the message has not yet been displayed.
17.3 Removing the lter
If you want to use the machine without the lter (D4), you must
remove it and notify the machine of its removal. Proceed as
follows:
1. Extract the tank (A17) and exhausted lter;
2. Access the menu as described in section "6.1 Access the
settings menu";
3. PRESS "WATER FILTER";
4. Press the selector corresponding to " REMOVE WATER
FILTER";
5. "CONFIRM FILTER REMOVAL": press
(or
press
to go back to the settings menu);
6. "FILTER REMOVED": the change has been saved. Press
to go back to the homepage.
Please note:
After two months (see date indicator) or when the machine has
not been used for 3 weeks, you should replace the lter even if
the message has not yet been displayed.
Loading ...
Loading ...
Loading ...