Loading ...
Loading ...
Loading ...
44
GB
D:\NORM'S JOB\SONY HA\SO17_STR-DH590_PMRF1\STR-DH590 (PMRF
01)\4726906121_GB\070TRU.fm
masterpage: Left
STR-DH590
4-726-906-12(1)
• Be sure to connect the receiver to an
HDMI input jack of a TV that is supporting
4K. You have to connect an HDMI cable to
an HDMI jack that supports HDCP 2.2
when you use a playback device for 4K
resolution video content, etc.
No image is output from the TV
screen when the receiver is in
standby mode.
• When the receiver enters standby mode,
the image from the last HDMI device
selected before you turned off the
receiver is displayed. If you are enjoying
content from another device, play the
content on the device and perform the
One-Touch Play operation, or turn on the
receiver to select the HDMI device from
which you want to enjoy content.
• Make sure “STBY.THRU” is set to “ON” or
“AUTO” in the “<HDMI>” menu.
The home menu does not appear on
the TV screen.
• Disconnect the HDMI cable from the
receiver and TV and then reconnect the
cable.
• Check that the appropriate input is
selected on the TV. Select the HDMI input
to which the receiver is connected.
• Press HOME to display the home menu.
• The home menu may take some time to
appear on the TV screen depending on
the TV.
HDR (High Dynamic Range) images
cannot be displayed in HDR mode.
• Depending on the TV or video
equipment, HDR images may not be
displayed in HDR mode. Check the video
capability and setting of your TV or video
equipment.
• Some video equipment may not output
HDR contents in HDR mode if “SIG. FMT.”
is set to “STANDARD”, even if both TV and
video equipment support HDR and
18 Gbps bandwidth. In this case set
“SIG. FMT.” of selected input to
“ENHANCED” in the “<HDMI>” menu.
When you select “ENHANCED”, use
Premium High Speed HDMI cables with
Ethernet which can support bandwidth
up to 18 Gbps.
The FM reception is poor.
• Extend and adjust the position of the FM
wire antenna (aerial) to a place where the
reception conditions are good.
• Place the FM wire antenna (aerial) near a
window.
• Position the FM wire antenna (aerial) as
horizontally as possible.
You cannot tune to radio stations.
• Check that the antennas (aerials) are
connected securely. Adjust the antennas
(aerials) if necessary.
• The signal of the stations is too weak
with automatic tuning. Use direct tuning.
• No stations have been preset or the
preset stations have been cleared (when
tuning by scanning preset stations is
used). Preset the stations.
• Press DISPLAY repeatedly so that the
frequency appears on the display panel.
Pairing cannot be done.
• Move the BLUETOOTH device closer to
the receiver.
• Pairing may not be possible if there are
other BLUETOOTH devices near the
receiver. In this case, turn off the other
BLUETOOTH devices.
• Correctly enter the same passkey that
was entered on the BLUETOOTH device.
Cannot make a BLUETOOTH
connection.
• The BLUETOOTH device you attempted to
connect does not support the A2DP
profile, and cannot be connected with
the receiver.
• Press BLUETOOTH to connect to the last
connected BLUETOOTH device.
• Turn on the BLUETOOTH function of the
BLUETOOTH device.
• Establish a connection from the
BLUETOOTH device.
FM radio
BLUETOOTH device
Loading ...
Loading ...
Loading ...