Loading ...
Loading ...
Loading ...
27
GB
D:\NORM'S JOB\SONY HA\SO17_STR-DH590_PMRF1\STR-DH590 (PMRF
01)\4726906121_GB\040CON.fm
masterpage: Right
STR-DH590
4-726-906-12(1)
Connection and Preparation
1 Connect the supplied
calibration microphone to
CALIBRATION MIC jack. Then,
place the calibration
microphone at your listening
position.
Be sure to set the calibration
microphone at the same height as
your ears.
• Insert the plug of the calibration
microphone all the way into the
CALIBRATION MIC jack. If the calibration
microphone is not connected securely,
measurements may not be made properly.
• Remove any obstructions between the
calibration microphone and the speakers.
2 When a subwoofer is
connected, turn on the
subwoofer and turn up the
volume.
Adjust and set the subwoofer as
follows:
• Turn the LEVEL to just before the
mid-point.
• If you connect a subwoofer with a
crossover frequency function, set the
value to maximum.
• If you connect a subwoofer with an
auto standby function, set it to off
(deactivated).
For details, refer to the operating
instructions of the subwoofer.
3 Start the Auto Calibration.
4 Press / to select [Start],
and then press .
5 Make sure that the
calibration microphone is
connected to the receiver,
and then press .
Before you perform Auto
Calibration
Check the following items:
• Disconnect the headphones.
• For accurate measurement, make
sure the environment is quiet and
free from noise.
• Make sure the speaker system is not
set to “OFF SPEAKERS”. Press
SPEAKERS on the receiver repeatedly
to select “SPK ON” (page 8).
To CALIBRATION MIC jack
Calibration
microphone
(supplied)
Note
Loading ...
Loading ...
Loading ...