Loading ...
Loading ...
Loading ...
Caring For Your Brewer
K-Cup® Pod Holder
To remove the K-Cup® pod holder from
the brewer, lift the handle and grasp the
top of the K-Cup® pod holder with one
hand while pushing up on the bottom of
the K-Cup® pod holder from underneath
with the other until it releases. After
cleaning, align the K-Cup® pod holder
with the opening using the two front
ribs as a guide and snap into place from
the top.
CAUTION: There are sharp needles that puncture the K-Cup® pod above the K-Cup® pod holder and in the
bottom of the K-Cup® pod holder. To avoid risk of injury, do not put your fingers in the K-Cup® pod holder.
NOTE: Always remove and dispose of the used K-Cup® pod after brewing.
Funnel
Washing the funnel ensures a fresh
beverage experience. The funnel
should be washed regularly and can be
removed from the K-Cup® pod holder by
pulling on it until it pops off. To replace
it, orient the snaps to the indent and
just snap it back onto the K-Cup® pod
holder.
Regular cleaning keeps your brewer running smoothly. Always be sure to turn off and unplug your brewer before cleaning.
Water Reservoir & Reservoir Lid
The water reservoir lid and water reservoir
should be cleaned periodically. Clean in
a dishwasher (top rack only) or hand
wash. To hand wash, use a damp, soapy,
non-abrasive cloth. Rinse the reservoir
thoroughly after cleaning. This will ensure
that no cleaning solutions remain in the
area as they may contaminate the water
supply. After rinsing, fill the reservoir with
clean water and return it to the brewer. Do
not dry the inside of the water reservoir
with a cloth as lint may remain. If needed,
repeat above procedures.
NOTE: If you are using a water filter inside the water reservoir, remove it
before cleaning.
Frother
Clean immediately after each use and before
first use.
To clean - frother and frother lid are top rack
dishwasher safe. After use, wait until the
frother has cooled then rinse before placing
in the top rack of the dishwasher, or cool
and hand wash immediately. Whisk should
be placed in the utensil basket of your
dishwasher. If washing by hand, only use
non-abrasive cleaning materials to prevent
damage to the inner surface of the frother.
To hand wash the whisk, soak in warm, soapy
water for 15 minutes then scrub with a soft
bristled brush. Dry thoroughly, and then
reassemble for next use.
Drip Tray
The drip tray can hold up to 8 ounces
of overflow and should be emptied and
cleaned occasionally. To remove, slide it
toward you, keeping it level to avoid spilling.
Clean in dishwasher (top rack only) or rinse
and clean with a damp, soapy, lint-free,
non-abrasive cloth.
LATTE
CAPP
COLD
LATTE
CAPP
COLD
Exit Needle
Remove the pod holder assembly and
detach the funnel. Locate the exit
needle on the inside bottom of the
K-Cup® pod holder. Insert a straightened
paper clip into the exit needle to loosen
any coffee grounds.
Entrance Needle
Lift the brewer handle and locate the entrance needle on
the underside of the lid. To clean both holes in the needle,
hold the brewer handle in the upward position and with
your other hand, carefully insert a straightened paper clip
into both holes. Gently move it around to loosen any coffee
grounds. Lower the handle completely and run two water-
only brew cycles. Do not insert a K-Cup® pod.
TIP: Refer to support.keurig.com for video instructions on cleaning the entrance/exit needles.
Brewer Exterior
Keep your Keurig® brewer looking its best
by cleaning the exterior from time to time.
Just clean with a damp, soapy, lint-free,
non-abrasive cloth. Never immerse the
brewer in water or other liquids.
LID
WHISK
FROTHER
Loading ...
Loading ...
Loading ...