Loading ...
Loading ...
Loading ...
8
4. Insert foam seal behind the top of the lower window sash and
against the glass of the upper window.
5. Plug into a grounded 3 prong outlet.
AIR CONDITIONER USE
Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
■ If you turn off the air conditioner, wait at least 3 minutes
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.
■ Do not try to operate your air conditioner in the cooling mode
when outside temperature is below 65°F (18°C). The inside
evaporator coil will freeze up, and the air conditioner will not
operate properly.
NOTE: In the event of a power failure, your air conditioner will not
operate at the previous settings when the power is restored.
Starting Your Air Conditioner -
Digital Control
1. Press POWER to turn on air conditioner.
NOTE: When air conditioner is turned on for the first time
after it is plugged in, it will display the default settings: Cool
mode, Turbo fan speed, 72ºF (22ºC). When it is turned on at
all other times, it will display the previous settings.
2. Select mode. See “Mode.”
3. Select fan speed. See “Fan Speed.”
4. Set temperature. See “Temperature.”
Mode
1. Press MODE until you see the indicator light come on for the
desired setting.
2. Choose COOL, FAN ONLY or POWER SAVER.
■ Cool - Cools room. You can select fan speed by pressing
Fan Speed. You can then adjust the temperature by
pressing the up or down arrow buttons.
■ Fan Only - Only the fan runs. The display shows “FO” (fan
only).
NOTE: Fan runs on Turbo speed only.
■ Power Saver - Fan and compressor run only when
cooling is needed. Fan stops running when room
temperature matches the Temperature control setting.
Compressor restarts in 3 minutes after the unit stops.
Compressor will not stop running for the first 6 minutes
after restarting unless unit is turned off.
Fan Speed
NOTE: The Fan Speed button will operate only when the Cool or
Power Saver mode has been selected.
1. Press FAN SPEED until you see the indicator light for the
desired setting.
2. Choose TURBO, HIGH, LOW or press AUTO.
■ Turbo - for maximum cooling
■ High - for normal cooling
■ Low - for sleeping comfort
1. Top of lower window sash
2. Foam seal
1
2
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Do not use an extension cord.
Do not use an adapter.
Do not remove ground prong.
Loading ...
Loading ...
Loading ...