Loading ...
Loading ...
Loading ...
7
INSTALLATION INSTRUCTIONS
1. The washing machine must be properly grounded. In the event of a short circuit, grounding can reduce the
danger of electrical shock.
2. Washing machine should be operated in a circuit separate from other electrical appliances.
INCLUDED PARTS
Before starting installation, make sure all included parts are
in the package inside the drum.
INSTALLATION REQUIREMENTS
ELECTRICAL REQUIREMENTS
1. A 120v, 60Hz, AC 15-or 20amp, fused electrical supply
is required. A time-delay fuse or circuit serving only this appliance should be used.
2. This washer is equipped with a power supply cord having a 3 prong grounding plug.
3. To minimize possible shock hazard, the cord must be plugged into a 3 prong outlet, properly grounded in
accordance with local codes and ordinances. If a proper outlet is not available, it is the responsibility of the
customer to have the properly grounded outlet installed by a qualified electrician.
4. If codes permit and a separate ground wire to be used, it is recommended that a qualified electrician
determine the proper ground path.
5. DO NOT ground to a gas pipe.
6. Check with a qualified electrician if you ar
e not sure the washer is properly grounded.
7. DO NOT have a fuse in the neutral or ground circuit.
8. Certain internal parts are intentionally not grounded and may present a risk of electric shock only during
servicing. Service Personnel – Do not contact the following parts while the appliance is energized: Drain
Pump, Door Lock, Drying Heater (Combo), Fan Motor (Combo).
LOCATION REQUIREMENTS
Selecting the proper location for your washer improves performance and minimizes noise and possible washer
“walk.” The washer can be installed under a custom counter or in a basement, laundry room, closet, or recessed area.
You will need:
• A water heater set for 120° F (49° C).
• A grounded electrical outlet located within 6 ft.( 1.8 m) of where the power cord is attached to the back of
the washer.
• Hot and cold water faucets located within 4 ft. (1.2 m) of the hot and cold water fill valves ,and wat
er
pressure of 20 - 100 psi (137.9 - 689.6 kPa).
• A level floor with a maximum slope of 1” (25 mm) under entire washer. Installing the washer on soft floor
surfaces, such as carpets or surfaces with foam backing.is not recommended.
• A sturdy and solid floor to support the washer with a total weight (water and load) of 200lbs.
• Do not operate your washer in temperatures below 32° F (0° C). Some water can remain in the washer and can
cause damage in low temperatures.
Water Hoses (2) Cable Tie
Transport
Hole Plugs (4)
Figure 2
Loading ...
Loading ...
Loading ...