Loading ...
Loading ...
Loading ...
12
Installation
Installation - Ducting version
1. If possible, disconnect and move
freestanding or slide-in range from
cabinet opening to provide easier access
to rear wall. Otherwise put a thick,
protective covering over countertop,
cooktop or range to protect from damage
and debris. Select a flat surface for
assembling the unit. Cover that surface
with a protective covering and place all
canopy hood parts and hardware in it.
2. Remove the metal filter (see paragraph
"Maintenance") top access the inside of
the range hood.
3. Perform any necessary cutout on cabinet
and wall as per "Dimensions and
clearances" paragraph for range hood
mounting and for vent system and conduit
passage.
Use the supplied template to perform the
cut out on cabinet.
Tape the template on the bottom of the
cabinet, check that printed arrows match
with the front edge of the cabinet (without
considering the cabinet door).
Cut as indicated.
4. Install the vent system before the range
hood. See „Venting methods“ and
„Dimensions and clearance“ paragraphs.
Note - for Ductless - recirculating -
installations:
Purchase the Ductless recirculating kit
Cabinet without ceiling:
Vent system is not required.
Cabinet with ceiling:
A 6" section of duct may be required to
connect transition to deflector.
5. Install a conduit long enough to reach the
junction box.
Run wires through hole according the
National Electrical Code or CSA
Standards and local codes and
ordinances.
There must be enough power supply
cable from the fused disconnect (or circuit
breaker) box to make the connection in
the hood’s Junction box/es.
Use caulking to seal all openings on wall.
Do Not turn on power until installation is
completed.
6. Fit the transition on top of the hood.
Loading ...
Loading ...
Loading ...