Loading ...
Loading ...
Loading ...
Black plate (7,1)
! Keep the front panel out of direct sunlight and
high temperatures.
Removing the front panel
1 Press h/Open to open the front panel.
If a disc has been inserted to this unit, press-
ing and holding h/Open enable to open the
front panel without ejecting a disc.
2 Press the release button, slide and re-
move the front panel toward you.
Take care not to grip it too tightly or to drop
the front panel and protect it from contact
with water or other fluids to prevent perma-
nent damage.
Release button
3 Put the front panel into the provided
protective case for safe keeping.
Attaching the front panel
1 Make sure the inner cover is closed.
2 Replace the front panel by clipping it
into place.
Resetting the microprocessor
The microprocessor must be reset under the
following conditions:
! Prior to using this unit for the first time
after installation
! If the unit fails to operate properly
! When strange or incorrect messages ap-
pear on the display
% Press RESET with a pen tip or other
pointed instrument.
RESET button
Reverse mode
If you do not perform an operation within
about 30 seconds, screen indications start to
reverse, and then continue reversing every 10
seconds. Pressing button B when power to
this unit is turned off while the ignition switch
is set to ACC or ON cancels the reverse mode.
Press button B again to start the reverse
mode.
<CRB3070-B>7
En
7
Section
01
Before You Start
Before You Start
Loading ...
Loading ...
Loading ...