Loading ...
2
JXBC67 KIT
The blower and motor assembly can be mounted on
an outside wall. This kit provides a means to mount
the blower outdoors with a protective cover. It should
be installed in an accessible and unobstructed
location, at least 10" above the ground.
STEP 1 CHECK PARTS SUPPLIED
• Separate the cover from the base assembly by
removing 5 screws. Lift off the cover. Retain all
screws.
• Remove the damper and the adapter plate. Be
careful not to damage the damper.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT - Save these instructions for local inspector’s use.
IMPORTANT - Observe All Governing Codes and Ordinances.
Note to Installer - Be sure to leave these instructions with the Consumer.
Note to Consumer - Keep these instructions for future reference.
Materials Required (not supplied)
• Approved liquid tight service connections for use
between the wire compartment on the base and
inside the structure.
• 7 wire nuts or other approved connectors.
• (6) 5/16” dia. fasteners compatible with the type of
material the base is being fastened to.
• 6” round duct, sufficient length to reach the outdoor
installation location.
• Two 6" round 90° elbows
• 6" round duct, length to reach blower location
• Electrical cable and connectors, sufficient length to
connect the downdraft vent to the remote blower
location. 14-guage min. is recommended, must
conform to local codes.
Tools required:
• Chalk or Pencil
• Measuring tape
• Drill with appropriate bits
Package of screws
• 1/4", 3/8" and
7/16" Nut driver
• Duct Tape
• Safety glasses
Adapter
Plate
Base Assembly
Damper
Loading ...
Loading ...
Loading ...