Loading ...
Loading ...
Loading ...
Black plate (124,1)
北米Model "A1300BE-C" EDITED: 2017/ 2/ 22
Keys and doors/Remote keyless entry system
the audible signal. You can also use the
same steps to restore the function.
1. Sit in the driver’s seat and shut all
doors and the rear gate (5-door models).
2. Hold down the unlock side of the
power door locking switch.
3. While holding down the unlock side of
the power door locking switch, pull the key
out and re-insert it into the ignition switch
at least 6 times within 10 seconds after
Step 2.
4. Open and close the driver’s door once
within 10 seconds after Step 3.
5. The hazard warning flashers flash 3
times to indicate completion of the setting.
Your SUBARU dealer can perform the
above procedure for you. Also, for models
with a combination meter display (color
LCD), the setting can be changed using
the display. For details, refer to “Vehicle
Setting” F3-43.
& Replacing the battery
Refer to “Replacing key battery” F11-45.
& Replacing lost transmitters
If you lose a transmitter or want to
purchase additional transmitters (up to
four can be programmed), your transmit-
ters should be reprogrammed for security
reasons. For details, contact your
SUBARU dealer and have the transmitters
programmed into the remote keyless entry
system.
& Certification for remote key-
less entry system
! U.S.-spec. models
CAUTION
FCC WARNING
Changes or modifications not ex-
pressly approved by the party re-
sponsible for compliance could void
the user’s authority to operate the
equipment.
NOTE
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This de-
vice may not cause harmful interfer-
ence, and (2) this device must accept
any interference received, includi ng
interference that may cause undesired
operation.
! Canada-spec. models
NOTE
This device complies with Industry
Canada’s licence-exempt RSSs. Opera-
tion is subject to the following two
conditions: (1) This device may not
cause interference; and (2) This device
must accept any interference, includ-
ing interference that may cause unde-
sired operation of the device.
REMARQUE
Le présent appareil est conforme aux
CNR d’Industrie Canada applicables
aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux
conditions suivantes: (1) l’appareil ne
doit pas produire de brouillage; (2)
l’utilisateur de l ’appareil doit accepter
tout brouillage radioélectrique subi,
même si le brouillage est susceptible
d’en compromettre le fonctionnement.
2-22
Loading ...
Loading ...
Loading ...