Loading ...
Loading ...
Loading ...
6
S-DD2-L FLUSH TOP
INSTALLATION GUIDE
Technical specifications and product sizes
can be varied by the manufacturer without
notice. Cut out dimensions are indicitive only
and physical measurement should be taken as
a precautionary measure to ensure no issues
arise with fitment.
STEP 1:
Refer to cutout dimensions required per unit as they
vary for each unit.
WARNING
INSTALLING THE RANGEHOOD
• Before carrying out the appliance installation,
please check that all components are not
damaged, in such a case contact your retailer
and do not carry out any installation operation.
Before the installation of the downdraft, please
remove the safety piece you can see in the
picture (Fig. 1). Leave all other protective tape
in place at this point. Furthermore, please
read carefully all of the following installation
instructions.
• Use Sirius ducting with a maximum length of 7
metres to the motor.
• Limit the number of elbows in the ducting, since
each elbow reduces the air capacity of 1 linear
meter. (Ex: if you use no. 2 x 90° elbows, the
length of piping should not exceed 5 meters).
• Avoid abrupt direction changes. (Optimum angle
45° when required)
• Use a 150 mm for 580mm models, - 200mm
ducting for larger models - constant diameter
pipe for the whole length.
Use ducting approved by standards enforced - see
www.siriusbrand.com.au for approved ducting
The manufacturer shall not be deemed responsible
for air capacity or noise problems caused by failure to
comply with the above instructions and no warranty
on the product shall be provided.
1. Before making the cutout, check that there are no
structural or other parts inside the cabinet where
the appliance is to be placed which could hinder
a proper installation. Check that the dimensions
of the downdraft and the cooktop are compatible
with the cabinet so that the installation can be
carried out properly.
2. Make a rectangular cutout in the back of the
cooktop:
• 542mm x 100mm for the 580mm model
• 842mm x 100mm for the 880mm model
• 1142mm x 100mm for the 1180mm model.
3. Put the downdraft in the opening, inserting it from
above as shown in (Fig. 2)
(Fig. 1) (Fig. 2)
NB: Remove only red parts
Loading ...
Loading ...
Loading ...