Loading ...
Loading ...
Loading ...
S-DD2-L FLUSH TOP
INSTALLATION GUIDE
15
CLEANING THE RANGEHOOD
Careful maintenance ensures proper operation and
good performances over time.
CAUTION
The hood must be disconnected from the electrical network, both by unplugging
the appliance from the socket and activating the magnetic circuit breaker (safety
cut-out), before removing the metal grease filters. After cleaning operations,
replace the metal grease filters as outlined in the installation instructions.
MAINTENANCE HOW TO PROCEED? ACCESSORY PRODUCTS TO USE
External
surfaces and
accessories
Do not use metallic
scrubbers, abrasive products,
or hard brushes.
To clean the external surfaces of the rangehood
and the light housing screen use only commercially
available household detergents diluted in water. Then
rinse with clean water and dry with a soft cloth.
Filter cleaning
After 30 hours of operation,
the downdraft will signal the
grease filter saturation.
The saturation is signaled by
the blinking of the 4 central
leds. To reset, hold down the
timer button for at least
3 seconds, while the carriage
is open.
The grease filters can be washed by hand or in the
dishwasher. These filters need to be cleaned on a
regular basis, otherwise they may represent a fire
risk. If frying or cooking with oil, the filers need to be
cleaned more regularly.
Refit the grease filters and front panel, making sure
that the panel is properly fitted at the sides so that it it
does not cause the downdraft to stop operating.
NB: Filters should be replaced approximately every 6 months, depending on style and frequency of
cooking. For high fat cooking it is recommended the clean the filters every 2 weeks.
PROBLEM SOLUTION
The rangehood
does not work.
Check that:
• There is not a power outage.
• A specific speed has actually been selected.
• The 6 pin connection is inserted properly.
• The red reset key, found over the electrical system box, is pushed.
• Make sure that the wires of the 9 pole connection are inserted properly in the
connector itself (during the connection phase, an excessive pressure could bend the
contacts).
The rangehood
has low
performance.
Check that:
• The motor speed selected is sufficient for the quantity of fumes and vapors present
in the room.
• The kitchen is ventilated well enough to allow air for intake.
• The non-return valves of the suctioning unit are free to rotate.
• The ducting is clear and not obstructed.
• Unit is only working on 2 speeds - refer to page 5.
• The correct minimum diameter ducting has been used
The rangehood
stops in the
middle of
operation.
Check that:
• There is not a power outage.
• The safety switch has not tripped (RCD or safety switch).
TROUBLESHOOTING
Loading ...
Loading ...
Loading ...