Loading ...
Loading ...
Loading ...
HOW THE RANGEHOOD WORKS
A: Light ON/OFF key
The light switches on and off only when the carriage
is fully OPEN.
Pressing this button with the carriage closed will
cause the carriage to open and then the light will
switch on .
The button also serves to switch off the light if it is on.
B: ON/OFF key
This starts the extraction carriage upward movement
and when it is fully open, it sets the second extraction
speed.
With the carriage open: it switches off the motor and
if on, the light; then it retracts the extraction carriage.
Automatic turn off:
After 4 hours of continuous working from the
last setup, the appliance turns off and closes
automatically. This ensures the unit cannot
accidentally be left running whilst away.
Grease filters saturation:
After 30 hours of working, the speed indicators “D”
will all flash simultaneously, signaling the grease filters
saturation.
To reset this alarm, hold down the “TIMER” button
for at least 3 seconds, while the carriage is open.
Calibration:
The rangehood carries out its self-calibration every 3
complete cycles of its extractable unit.
By pushing the “TIMER” key 6 times consecutively
(MAX break between one push and the other is 3
sec.) all the LEDs will flash and the calibration will be
reset.
After the next 3 cycles the downdraft will carry out its
self-calibration.
Stand-by:
When the extractable unit is closed and the light
is switched off, the control panel, after 6 seconds,
activates the Stand-by function, reducing the
brightness of the leds.
This function can be stopped by pressing ON/OFF
or LIGHT key.
Safety close function:
If an obstacle is preventing the downdraft from
lowering completely, the downdraft will automatically
raise to prevent damage to the unit.
C: Decrease fan speed key
This reduces the speed of the extractor motor from
the 4th speed until the motor switches off, without
closing the pullout carriage.
D: Fan speed Indicators
• This signals the speed setting, by only the
relevant LED switching on.
• Lights flashing signals reminder to wash mesh
grease filters. (see grease filter saturation)
E: Increase fan speed key
This increases the speed of the extractor motor, from
1st to 4th speed, without moving the extractor panel.
F: 10 Minute shut-off timer
10 min after setting, it serves to stop the extractor
motor, close the carriage and switch the lights off,
if they are on. The set function is signalled by the
flashing LEDs “D” for the set speed. The timer can
be cancelled by pressing the key again.
WARNING
This operation has to be carried out by a
specialised technician.
S-DD2-L FLUSH TOP
INSTALLATION GUIDE
14
Light On/Off Decrease fan
speed
Fan speed
indicators
Increase fan
speed
10 min shut-off
timer
Loading ...
Loading ...
Loading ...