Loading ...
Loading ...
Loading ...
9
ENGLISH
Accessories
WARNING: Since accessories, other than those
offered by CRAFTSMAN, have not been tested with
this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
CRAFTSMAN recommended accessories should be
used with thisproduct.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact CRAFTSMAN, call 1-888-331-4569.
1. Remove the screw
26
and nut located on the other
end of screw. Remove the side cover
27
from the left
side of the planer.
2. Place a light coat of E.P. multi-purpose grease on the
teeth of the gears, and a light coat of spray lubricant on
the chains. Replace the side cover.
3. Place the planer on its back and squirt oil on the feed
roller bushings at each end of the feedrollers.
4. Replace side cover.
Fig.N
26
27
Fig.O
Cleaning
WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performingthis.
WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into aliquid.
Keep Machine Clean
Periodically blow out all air passages with dry compressed
air. All plastic parts should be cleaned with a soft damp
cloth. NEVER use solvents to clean plastic parts. They could
possibly dissolve or otherwise damage the material.
WARNING: Wear certified safety equipment for
eye, hearing and respiratory protection while using
compressed air.
Failure To Start
Should your machine fail to start, check to make sure the
prongs on the cord plug are making good contact in the
outlet. Also, check for blown fuses or open circuit breakers
in the line.
Lubrication & Rust Protection
Apply household floor paste wax to the planer table,
extension table or other work surface weekly. Or use a
commercially available protective product designed for
this purpose. Follow the manufacturer’s instructions for
use and safety.
Lubrication (Fig. N, O)
The gears in the gear box and the feed roller bushings
should be lubricated periodically.
WARNING: Disconnect tool from power source.
Fig.M
24
25
Loading ...
Loading ...
Loading ...